What do I hook the remote wire to?
Wiring the remote turn on wire with an aftermarket head unit is pretty straightforward. Simply connect another piece of blue primary wire to the blue wire in the wiring harness and run the primary wire back to the amplifier to terminate in the remote turn on terminal.
Can a dB link amp be connected to a starter relay?
I have a DB Link Audio 200 Amp Fuse and Fuse holder. Can this fuse be use for the main 1/0 AWG cable from the battery (mounted in the trunk) to the starter relay and the power to my JL Audio Amp HD900/5? John, Your vehicle’s starter relay should not get connected to your amp’s power cable.
How are virginize keys stored in the ECU?
The virginize keys are values that are “10” in the original dump but must be changed to “00” to tell the computer to go into auto-programming mode. The Key counter is a number count, in inverse HEX, of how many keys are currently stored in the ECU.
How to insert third transponder key in ignition lock cylinder?
Insert third transponder key into ignition lock cylinder for registration DO NOT TURN ON. After security light goes off remove third key from ignition. The security light should extinguish and then commence to blink regularly. 5. Wait 30 seconds for the programming cycle and programming mode to close.
Can a valet key be inserted into a master key?
The first two keys are internally (inside the ECU) designated as MASTER keys and the 3rd key inserted will be internally designated as the VALET key. should stop blinking right away. If you insert a VALET key, the security light will remain solid for 2 seconds and then go out.
Do you need a remote start wiring diagram?
Every remote start wiring diagram contains information from other people who own the same car as you. If you want to install a new remote car starter, you’ll love our remote start wire guides.
Where can I get a dashcam installation kit?
A dashcam installation kit from The Dashcam Store™ is used in this procedure to make the job quick and easy: WARNING: this type of installation should be performed by a qualified individual or business only. Working with your vehicle’s power system can be dangerous to both you and your vehicle if you do not know what you are doing!
Where do you put the hardwire on a dash cam?
Use a zip tie to bundle the excess power wire together. Then, safely secure the wiring to a solid mounting point underneath the dashboard or behind the kick panel using more zip ties. Insert your key in the ignition and turn it to the run position.
Where do you put the fuse on a dashcam?
Install the fuse you just removed into the installation kit add-a-fuse circuit. The first image below shows the add-a-circuit as you receive it from The Dashcam Store™. The second image is with your car’s original fuse installed into the add-a-circuit. Plug the add-a-circuit in to the empty spot where your “hot in start” fuse was originally.