What causes a Hyundai Santa Fe to stall?
The crankshaft position sensor may fail, causing engine stalling or a failure to start. Replacement or the failed sensor will commonly correct this problem. The average cost for a Hyundai Santa Fe General Diagnosis is between $88 -$111.
Why does my Santa Fe engine shut off while driving?
From what I’ve been researching the Santa Fe’s have a faulty “Crank-Shaft Sensor” in which it makes the SVU just shut off while driving. The manufacture knows of this problem but continues to ignore any and all permanent solutions. This problem isn’t the worst part though!
How much does a Hyundai Santa Fe general cost?
The average cost for a Hyundai Santa Fe General Diagnosis is between $88 -$111. Learn More While driving my car around 25mph, without warning it suddenly died. Luckily I was traveling on a street that did not have alot of traffic and I was able to get my vehicle off of the road. I waited about 30 minutes, and then it started.
Oxygen Sensor – The oxygen sensors measure the exhaust gasses after they exit the combustion chamber. The ECU uses this data to make adjustments to the air/fuel mixture. If one of them has gone bad, then it could lead to stalling. There are many other sensors that can cause your Santa Fe to stall. These were just some of the most common ones.
What to do if your Santa Fe is stalling?
Before troubleshooting any automotive issue, including stalling issues with the Santa Fe, make sure that you check the vehicles trouble codes with an OBD2 scanner. Trouble codes are always a great place to start diagnosing problems on today’s modern computer controlled vehicles.
Can you run a scan on a Santa Fe?
If you don’t own/want to buy a scanner, most local parts stores will run a scan for you at no cost (they want to sell you the parts). Here are some of the issues that cause the Santa Fe to stall out.
Where is the throttle position sensor on a Hyundai Santa Fe?
Your Hyundai Santa Fe uses a series of complex sensors to report what is going on to the ECU. The ECU then uses this information to adjust the timing, air fuel mixture, and more. When one of them goes wrong, it can lead to stalling for sure. Throttle Position Sensor – The throttle position sensor is typically located on the gas pedal.
What causes a rough idle or a ses?
A Rough Idle or a SES can sometimes be caused by a change in the throttle body position sensor calibration. To correct any accidental changes in throttle body calibration, use these procedures to recalibrate. Note: These procedures are a little tricky to do. You must get the timing just right Use a stop watch to help the precision of your timing.
What causes rough idle on a Hyundai Santa Fe?
On the 2.7L V6 and 2.4L 4 Cylinder, a defective exhaust gas recirculation (EGR) switching valve may cause an intermittent rough or unstable idle engine. The average cost for a Hyundai Santa Fe General Diagnosis is between $88 -$111.
What’s the problem with my 2015 Santa Fe?
Going to have the fuel filter checked next. 2015 Santa Fe shutters after it has been come to a stop and been in idle for at least 10 seconds. It’s covered in warranty so we’ll be taking it in to the dealership. Same problem. They bypassed my egr : ( Misses underload. When I restart…runs fine until idling under load or backing up.
Why does my Hyundai Santa Fe take off faster?
Vehicle Takes off Faster – With the engine idling higher, people report feeling the vehicle take off when releasing the brake pedal. This can make driving more dangerous. There are a lot of potential causes to P0507.
What does idle air control code p0507 mean?
P0507 is a fairly typical OBDII trouble code. It is typically triggered when the engine idle speed is 200 rpm or more over the predetermined limit set by the manufacturer. It is a generic code, which means that it has the same for the Hyundai Santa Fe as any other vehicle. P0507 Symptoms
Why did my Hyundai Sonata engine die while driving?
I have a Hyundai Sonata 2002 automatic which has just broken down. What happened is that while driving the engine suddenly stopped and the check engine light turned on. I attempted to start the engine but soon after it started it died again. The next time I start it, the engine just cranks but won’t start at all.
What should I do if my Hyundai engine won’t start?
Key Immobilizer faulted (unlikely unless you’re using a non-standard key or bypassed it for a remote starter or some crazy electrical nonsense). If it is this, to replace the immobilizer unit and/or keys could be around $300 or so. Crank Angle / Crank Position / Cam Angle / Cam Position sensor (s).
Is the Santa Fe 3.5 liter a top heavy car?
When driving through curves, the 3.5-liter Santa Fe can exhibit a slightly top-heavy sensation. We bought a 2005 Santa Fe 2.7L V-6 AWD GLS new in Maryland and drove it for 12 years and over 150,000 miles with no issue what so ever with the mechanical, body or anything for that matter other than
Why does my 2017 Hyundai Santa Fe not start?
See all problems of the 2017 Hyundai Santa Fe . Navigation screen does not turn off after the ignition is turned causing the battery to drain and car will not start. My new 2019 Hyundai sante fe from the time I bought it had the yellow check engine light come on. It said the bsm system wasn’t working.
How often does a crankshaft sensor throw a code?
It doesn’t do it everyday, just once in a while.To make a long story short, the “crankshaft position sensor” was bad. The sensor costs about $60 and is very easy to put in. (less than an hour) The wires rot on the sensor and touch each other causing a signal loss from the sensor. By the way; crankshaft sensors usually don’t throw a code.