What causes a Harley Davidson to not turn over?
If the bike does not turn over, the issue can be battery, starter, starter relay. If turns over, but no start, determine if the issue is electrical or fuel related. Check for spark.
What to do if your Harley Davidson won’t start?
Get (2) 12″ pieces of wire and stripe 1/2″ from each end. Insert 1 wire into the female terminal that would be #30 in the fuse panel socket. Insert the other WIRE (NOT END of 1st wire) into #87 of the fuse panel socket. 6) Make SURE bike is in NEUTRAL. 7) Turn on ignition ON and Kill switch to run.
Why is my Harley Davidson Road King not starting?
If you have a Tachometer, disconnect it. A bad tach can interrupt proper coil function. i have problem error code U1301 in Harley Davidson Road King 2009 and test everything not starts . I have a 92 FXRSP, I recently replaced my switches and I had a new battery.
What does it take to start a Harley Davidson Sportster?
This article applies to the Harley Davidson Sportster. What does it take to start a Sportster? When you turn the ignition switch to the on position, current is sent to the start button. Pressing the button sends power to the starter solenoid, which sends a large amount of current from the battery to the starter to turn the motor.
What to do when your Harley Davidson won’t start?
Try neutral with clutch pulled in. Also battery connections , solenoid wire. The security system lights only flash after I turn off the bike. I have the bike in neutral and I even tried pulling in the clutch a couple of times. I checked the wire to the solenoid and it had power.
Why does my Harley Davidson not have power?
I checked the wire to the solenoid and it had power. Almost certainly it’s a battery problem, either low charge or bad cable connection. Charge the battery on a good bench charger, not a Tender, but a real charger. Remove and reconnect both battery cables making sure they are tight and connections are clean.
Why does my Dyna FXDC bike not start?
Alarm, clutch inhibit & neutral safety all come from the TSSM. The TSSM controls the start relay. 09 Dyna FXDC, got power everywhere. Lights,Horn,Turn`s,Fuel Pump,Dash, Turn the key on, hit the run/stop switch, push the start button and Nothing. Not even a click or a buzz. Bike has been sitting for about 2 weeks.
Why does my Harley Davidson make a hard clicking sound?
Clicks when trying to start does not engage. I have a Harley-Davidson 1999 sportster 1200. I get a hard fast clicking sound when trying to start. I Have put the battery on a charger and let it charge overnight. It still does the same thing. Is this a bad battery?
What to do if your Harley won’t start?
Take the 2 relays and swap them……….see what happens. Check positive and neagative cable tightness at starter and ground lug. The oil spill thing has nothing to do with the no start issue. too.) then see if the bike will start. you can use starting fluid thru the intake but use it spareingly.2 short spirts of s/ fluid.
What kind of engine does a Dyna Super Glide have?
The bike is a 2003 Dyna Super Glide stock engine. Does anyone have any suggestions as to what might cause this or has it every happen to anyone else. Things were fine until last week I stop to get gas after riding maybe 40 miles or so and when I was ready to go the bike won’t start. After waiting say 15 or 20 minutes, it starts fine.
Why is the fuel pump not working on my Harley?
Key fob battery was dead. Discovered that with a good battery in the fob when I turn ignition to on I can hear the fuel pump charging the system. When the fob is out of range everything works except the fuel pump. Hence the no start issue. Thank you a thousand times over. I spent Over two hours checking every electrical item I could.
When did I replace the battery on my Street Glide?
I have a 2014 Street Glide Special with about 40k miles. I replace the main battery in February and then last week I took the bike for a ride. After stopping for a drink, the bike would not start.
If the bike does not turn over, the issue can be battery, starter, starter relay. If turns over, but no start, determine if the issue is electrical or fuel related. Check for spark.
Take the 2 relays and swap them……….see what happens. Check positive and neagative cable tightness at starter and ground lug. The oil spill thing has nothing to do with the no start issue. too.) then see if the bike will start. you can use starting fluid thru the intake but use it spareingly.2 short spirts of s/ fluid.
Key fob battery was dead. Discovered that with a good battery in the fob when I turn ignition to on I can hear the fuel pump charging the system. When the fob is out of range everything works except the fuel pump. Hence the no start issue. Thank you a thousand times over. I spent Over two hours checking every electrical item I could.
Harley Davidson Won’t Start But Cranks HELP! – YouTube Harley Davidson Won’t Start But Cranks HELP! If playback doesn’t begin shortly, try restarting your device.
What does it mean when your motorcycle won’t start?
There are few things that are more disappointing than getting psyched up to go riding only to be hit with realization that your motorcycle won’t start. The engine is turning over, but nothing is happening except for the fact that your frustration level is rising.
What should I do if my Harley Davidson won’t start?
Here’s where to start your search when your bike won’t start and you have no idea why. This article applies to the Harley Davidson Touring models (2009-present). So the weekend has finally arrived. Boots on, gloves, jacket and helmet: check. You even checked your tires: 36 front and 38 rear.
If you have a Tachometer, disconnect it. A bad tach can interrupt proper coil function. i have problem error code U1301 in Harley Davidson Road King 2009 and test everything not starts . I have a 92 FXRSP, I recently replaced my switches and I had a new battery.
Why does my 1999 Road King not start?
I haveA 1999 road king have not rode it in about three years ,gas tank had treatment ,has been started and ran fine however tried to start, will start with choke on. Sprayed carburetor with carb cleaner still starts only on choke ,goes off when choke is taken off. I appreciate the post for valuable information.
What should I do if my engine won’t start?
You should see a bright spark jumping the gap in the spark tester. If you don’t see a spark, repeat the test. This time, adjust the spark tester to 30KV. If you still don’t see a spark, repeat the test and set the tester to 10KV. If this time you see a spark or no spark, you have a problem with the ignition system.
What to do if your Harley Davidson is not starting?
If you only have spark on the front cylinder, swap plug wires (front to rear, rear to front ). Now see if you (only) have spark on the rear cylinder. If you do not have power to the coil; Use a small jumper wire and power your coil directly from the battery. This will will bypass your harness and switches.
What to look for when your engine won’t start?
Check for a blown fuse that may be preventing a circuit from working properly, like the fuel injection or computer system. To operate efficiently, an internal combustion gasoline engine needs a good spark, the right amount of fuel, and good compression (a healthy mechanical condition).
Why does my Harley Davidson bike not start?
If the engine doesn’t crank, it could be because of a failure at any of those stages, a weak battery, or a bad starter. If the motor cranks and still won’t start, then it is likely a fuel or spark issue. A few tests can be performed to quickly track down the problem.
Why does my Screaming Eagle Bike not start?
Just picked up a 2008 Screaming Eagle Ultra Classic. The bike will not start, and I do not hear the fuel pump kick in. also there in not power at the 15 amp fuse for the fuel pump. Not sure if that is the problem though as that fuse may get power after a relay closes? fuse is good.
How often do Harley Davidsons start to misfire?
We see it 2 or 3 times a year and usually in batches of 3 or 4 vehicles. If water gets into the supply tank it will go to the bottom. eventually it will build up until the pump starts to suck it out. At first it will suck a fixture of fuel and water so the vehicle will run as described. Thank you Tony.
What should the Run switch read on a Harley Davidson Sportster?
Remove the kill switch from the right handlebar grip. Measure the resistance/continuity of the switch with the switch unpressed using the same method described for testing the run switch. The reading should be 0.1 ohms or less. Press the switch and measure again. The reading should now be “OL” or infinite, meaning no connection is present.
What does it mean if your Harley is not starting?
Harley Wobble – Read More 2. Harley Not Starting – Read More 3. Harley Started to Misfire – Read More 4. Oil Dripping from Harley Air […] […] Harley Wobble – Read More 2. Harley Not Starting – Read More 3. Harley Started to Misfire – Read More 4.