Is there any pressure on the brake pedal?
Never got any air out the second go around, and even ran a whole bottle through just to be sure. The pedal still feels the same, no pressure. You can even turn the rotor slightly when the pedal is down. Anybody have an idea on what may be going on? The lines going to caliper are tight, with no leaks anywhere.
Why is the gas pedal not working on my Infiniti?
There is no misfire or lack of power other then the throttle body not opening. I also replaced the sensor on the gas pedal. There is times when I do start it and it revs up great like it should you put it in gear and it responses like it should with just a small tap to the accelerator. But just after a few second its goes back doing the same thing.
What are the brake codes on my Infiniti?
The two codes that come up are p2136 and p2128. The brake fluid is fine. These lights are on all the time is not when I drive the car. I can leave the car siting for a few minutes and then start it back up.
What happens when there is no pressure on the brakes?
Bled the brakes from passenger rear to driver rear to passenger front driver front. Still no brake, pedal goes to the floor. Iperformed this procedure twice once with the truck off and once with the truck running. Still no brake pressure. Is there something else that needs bleeding? There is nothing exceptional about the bleeding process.
Never got any air out the second go around, and even ran a whole bottle through just to be sure. The pedal still feels the same, no pressure. You can even turn the rotor slightly when the pedal is down. Anybody have an idea on what may be going on? The lines going to caliper are tight, with no leaks anywhere.
Why does my brake pedal stick when bled?
When the system is manually bled, the pedal is often depressed completely, moving the primary and secondary pistons to their extreme forward position (figure 2). The primary piston can stick even though there are springs attempting to push it back in position.
Why is there no pedal on my new master cylinder?
No Pedal with New Master Cylinder Installation – Quick Fix or Check? A “no brake pedal” condition can be encountered after a new master cylinder is installed, leading the technician to believe that the master cylinder is defective.
Is there a way to bleed the Master brakes?
Sounds like you need to bleed the master. Just like the calipers you need to get the air out of the MC. Put a hose on the bleeders on the side of the MC and loop it back into the top of the master. Pump brakes and open the bleeder just like on the caliper.