Is the electric fault and ABS module on?
I have an international 4300 and the electric fault and abs module is on. At first one of my drivers left the door open I have an international 4300 and the electric fault and abs…
What’s the electric fault on an international 4300?
I have an international 4300 and the electric fault and abs… Vocational, Technical or Tra… I have a 2012 international with datalink issues Data link issues. Looking for help troubleshooting cause
Is there an electrical fault on my international MaxxForce 7?
We replaced the long block on a 2011 international Maxxforce 7. We finally got it all back together and went to try and fire it up and basically got nothing but an electrical fault on the dashboard and the truck doesn’t do anything. I can hear the relays clicking but getting nothing. 1HTJTSKL5BH359690. That is a cluster fault .
What does it mean when your ECM lights up?
I’ll be going over to it here in a little bit. If the wait to start lights up , it usually means the ECM is powering up . We need to confirm the the TCU is powering up by looking for the current gear on display . I will be in and out today but will check in .
Why is there a recall on my ProStar?
In certain driving conditions, such as on a long down-hill grade, the fuel line may burst if the fuel pump cooling circuit screen becomes restricted. Recall Details
Are there any recalls on 2017 International ProStar trucks?
Problem: Navistar, Inc. (Navistar) is recalling certain 2017 International ProStar, LoneStar, 9900i, and TranStar trucks. The affected vehicles have a metallic battery cover latch that may unlatch and contact the battery jump start stud, causing an electrical short to ground if the jump start stud is not covered. Recall Details
Why is my abs light on but no code?
My ABS light was on but no code any where. First, you need to know how to get ABS codes out of the computer. This will tell you what’s going on. More then likely it is a rear axle. From there, go to that axle and swap the wiring side to side (put right side wiring on left sensor, and left sensor on right side wiring).
https://www.youtube.com/watch?v=mDbd6m4o5gs
What’s the ABS light on an international 4300?
2012 INTERNATIONAL 4300 DT466 MAXFORCE… *****************. I HAVE AN ABS LIGHT AND WARNING BEEPER CONSTANT, I HAD A … read more Our 2009 International 4300 MaxForce DT (7.6L) truck is shifting into neutral as we are driving down the highway. We have to pull off and turnoff engine 5 minutes and then restart and drive for anothe … read more