Is the DT466 over heating still a problem?
We have a 2001 International 4700 with the Dt466. The cooling sytem has been gone through but it is still having overheating problems. Does anybody know of any fixes or a better radiator design than this 1/2 of a radiator crap.
Is the DT 466 engine viscous or air operated?
I run DT 466 right up 1050-1100 EGT and never had too much of a problem but its also intercooled so that makes big difference Thought of one more thing, does it have a viscous fan drive on it or air operated. If it’s viscous run the engine and get it hot, pop the hood and check and see if the fan is locked up or turns freely.
What causes low block pressure on a DT466?
Either way, removed the water pump, very easy to do, and check the rear half of the front cover where the water pump goes. This is a common problem when a water pump bearing fails the impeller on the water pump eats out the flat aluminum boss on the rear half of the front cover. This causes low block pressure and poor cooling.
Where to buy dt466e engine assemblies for sale?
Shop our massive inventory of rebuilt International DT466E Engine Assemblies at unbeatable prices. Enjoy our hassle-free online checkout or call to speak to an expert. Cooling Assembly. (Rad.,
What does no check engine light mean on dt466e?
Sorry forgot to say its a 2000 international 4900 with a 6 spd eaton. Thanks. Do you have a check engine light? No light = no ECM power (key on, engine off). Look at the back of the key switch and see if the wires are burnt in the connector. They may have lost connection and you have no power going out.
https://www.youtube.com/watch?v=C19kOx1GogM
How do you turn off ignition on DT466?
Take a screwdriver and pry linkage outward towards the frame rail. Then release it and the linkage should go back on its own freely and bottom out and bounce once . oh yes, with ignition on then I turn it off the linkage only clicks ones but I have not tried it with a screwdriver,
When to disconnect the actuator on a DT466?
If > 0.25 V disconnect the actuator harness and retest. If > 0.25 V, do 12-pin Actuator Power Voltage Check . If < 0.25 V, the concern is either high resistance in wiring or the VGT actuator. Do Harness Resistance Checks to confirm integrity of wiring.
Where is the HPOP on a 1999 dt466e?
On the left side of the engine mounted on the back side of the front cover is the high pressure oil pump. Its also right above the air compressor ( if equipped) or ps pump. On the hpop there is a valve near the bottom of it.
What should I do if my 1999 dt466e dies?
1. Check the strainer to make sure that it is not plugged. 2. Check all of you “clean power and ground” connections to the ECM. The will be one each in the battery box then another two or three wire connector near the starter.
How much Freon does 2000 International 4700 truck hold that?
How much Freon does 2000 international 4700 truck hold that… I have a 2000 International 4700 rollback. Out of nowhere I I have a 2000 International 4700 rollback. Out of nowhere I lost right blinker.
What kind of truck is the International 7400?
2004 International 7400 Tandem Axle Dump Truck, DT530 Engine, Exhaust Brake, 275 HP, Allison 6, 147,461 Miles, 7,963 Engine Hours, 58,000 Lb GVWR 18/40K, Diff Lock, Walking Beam Suspension, 315/80R… See More Details National 500D ,60 feet ,16 ton. 2003 IHC 7400 Dt466, 10 speed,58,695 miles,7,957 hours.
Can a 2005 International shut off while driving?
I have a 2005 International with a DT466. The issue I’m having is without warning, while driving down the road the truck will lose power and then shut off. No engine light comes on, no codes in the Dash changed the fuel filter checked the fuses in the battery box, Checked the relays underneath the hood and replaced the camshaft sensor.