How to remove the part that limits speed on a 150cc scooter?
Pull the small washer from around the front pulley bar upon removing the outside of the front pulley wheel. This washer limits the speed of your 150cc scooter. Put the front pulley wheel back onto the pulley rod, replace the variator case cover and the intake case, and put the kickstand back on the scooter.
How to tune a Honda GY6 150cc scooter?
The fuel & air intake make up several different components, each one crucial to help your GY6 150cc Ruckus Swap run smooth. A set of Main Jets, Slow Jets, and Needles are required to tune the scooter for the correct AFR. Tuning is a difficult process and will not be for everyone.
What’s the acceleration of a 50cc Scooter?
At 50mph, the actual scooter speedometer reads closer to 60mph. It’s hard to find acceleration times for scooters, so it’s hard to compare these numbers with anything else. I did find some times for 0-30mph for a few 50cc scooters and they were typically in the 10-20 second range, so you can see how much quicker a 150cc scooter is.
Where is the kickstand on a 150cc scooter?
The kickstand is held onto the side of the scooter with a small pin located near the top of it. Loosen the top of the pin, pull it slightly out and pull the kickstand off of the side of your scooter. This will give you access to your scooter’s variator case.
How can I increase the speed of my 150cc scooter?
In addition to the smallness of their engine’s output, this diminished speed can be attributed to a small washer found in the scooter’s drivetrain or variator system which restricts the top speed of the scooter. Removing this piece is a completely legal procedure which will improve the overall acceleration power and top speed of your 150cc scooter.
The kickstand is held onto the side of the scooter with a small pin located near the top of it. Loosen the top of the pin, pull it slightly out and pull the kickstand off of the side of your scooter. This will give you access to your scooter’s variator case.
How do you remove the variator case on a scooter?
The kickstand is held onto the side of the scooter with a small pin located near the top of it. Loosen the top of the pin, pull it slightly out and pull the kickstand off of the side of your scooter. This will give you access to your scooter’s variator case. Remove the molded intake case.
Which is better a 50cc or 150cc scooter?
Though more powerful than their smaller, 50cc brothers, 150cc scooters can still be somewhat sluggish compared to larger motorcycles and automobiles.