How to remove ignition assembly from steering column?
There are two parts to removing this component. First, insert the key and unlock the steering wheel. Next, use a flat blade screwdriver to press a small metal push pin that is located underneath the ignition lock cylinder. By depressing this switch, you’ll be able to unlock the cylinder from the housing.
How to remove a ignition switch without the key?
- Step 1: Disconnect The Battery.
- Step 2: Remove The Steering Wheel.
- Step 3: Remove Indicator and Wipers Switches.
- Step 4: Remove Sleeves From Steering Column.
- Step 5: Disconnect All Electrical Connection Leading To Ignition Switch.
- Step 6: Remove The Mounting Bolts.
- Step 8: Lock the Key Cylinder.
- Step 9: Use A Screwdriver.
How do you remove ignition switch from car?
Insert a straightened out paperclip into the slot just to the left of the key cylinder. This will lock the cylinder from starting. Inserting your screwdriver into the cylinder and turn it as far as you can to the right. Pull on both the paperclip and the screwdriver to gently slide the switch out of its current position.
How can I Turn Off the ignition without a key?
Be sure to make the hole large enough for you to insert your screwdriver, and drill to the back of the key slot. Insert a straightened out paperclip into the slot just to the left of the key cylinder. This will lock the cylinder from starting. Inserting your screwdriver into the cylinder and turn it as far as you can to the right.
Where is the cover on the ignition switch?
On most vehicles, there is a plastic or metal cover on the ignition lock cylinder. Remove the small screw that holds this cover on, typically located on the bottom of the switch. Once the screw has been removed, carefully slide the cover off the ignition lock cylinder.
How do you remove an ignition lock cylinder?
Step 8: Loosen the screws on top of the ignition lock assembly. The lock cylinder is secured to the lock assembly by a button on the bottom of the housing and two screws on top of the lock assembly. Loosen the two screws on top to allow you to remove the cylinder.
What should I do if I need to replace my ignition switch?
Reconnect the cable to the negative (-) terminal on the battery, then insert the key into the ignition and turn it to start the vehicle. The vehicle should start without any issue. If it doesn’t, remove the ignition switch and reinstall it. Shut the engine off (if it starts) and disconnect the battery again.
What’s the best way to replace an ignition lock?
Step 10: Tighten the two screws on top of the lock cylinder. After the new ignition lock cylinder is secure inside the housing, tighten the two screws on top of the lock body. Step 11: Replace the ignition lock cylinder cover. Reinstall the ignition lock cover and tighten the screw underneath.
On most vehicles, there is a plastic or metal cover on the ignition lock cylinder. Remove the small screw that holds this cover on, typically located on the bottom of the switch. Once the screw has been removed, carefully slide the cover off the ignition lock cylinder.
How do you remove a battery from an ignition switch?
Use an appropriate sized wrench to loosen the nut holding the cable on the negative (-) terminal and then slide it off the post. You don’t need to remove the positive cable from its terminal. Tuck the negative cable to the side of the battery to make sure it doesn’t accidentally come into contact with the terminals.