How to install a starter on a Kawasaki Bayou 300?
Slip the starter cable onto the starter motor terminal post, then tighten the terminal nut, using a 10 mm socket and a socket wrench. Push the rubber boot over the terminal. Reinstall the left engine cover and gasket, using a 10 mm socket. Tighten the engine cover bolts to 7.6 foot-pounds. Plug the engine cover wiring into the ATV’s wiring harness.
Can a Kawasaki Bayou 300 be used as an ATV?
Although the Bayou 300 was phased out of Kawasaki’s lineup in 2005, it remains a suitable choice as a workhorse ATV. Starter motor failures are a common problem, especially with older Bayous; however, a damaged starter is not a deal buster.
Why does my Kawasaki Bayou 220 not start?
Kawasaki Bayou 220 will not start. New battery, fresh tank of fuel and a new spark plug (gapped at 0.028). In trying to outsmart the thing for a Christmas ride, I fiddled (not a mechanic term) with th … read more my atv stalls when i close the choke. I took the carb apart my atv stalls when i close the choke.
Where is the drain plug on a Kawasaki Bayou 300?
Unscrew the crankcase drain plug, located at the center of the engine crankcase, using a 17 mm socket and a socket wrench. Drain the engine oil, then screw the drain plug into place by hand. Tighten the crankcase drain plug to 22 foot-pounds, using a torque wrench.
Slip the starter cable onto the starter motor terminal post, then tighten the terminal nut, using a 10 mm socket and a socket wrench. Push the rubber boot over the terminal. Reinstall the left engine cover and gasket, using a 10 mm socket. Tighten the engine cover bolts to 7.6 foot-pounds. Plug the engine cover wiring into the ATV’s wiring harness.
Although the Bayou 300 was phased out of Kawasaki’s lineup in 2005, it remains a suitable choice as a workhorse ATV. Starter motor failures are a common problem, especially with older Bayous; however, a damaged starter is not a deal buster.
How long does it take to install a motorcycle starter?
Starter Motor installation on my 1986 Kawasaki Bayou KLF-300 ATV. Thought of a different approach to removing and re-installing the starter motor, without having to take the engine side cover off every-time due to the little sprocket falling off inside (pain-in-the-neck!). This way I can remove and re-install the motor in about 10 minutes.
Unscrew the crankcase drain plug, located at the center of the engine crankcase, using a 17 mm socket and a socket wrench. Drain the engine oil, then screw the drain plug into place by hand. Tighten the crankcase drain plug to 22 foot-pounds, using a torque wrench.