How to install 7 way connector on Subaru Outback?
Next I recommend installing the 7-Way RV Upgrade Kit # ETBC7L which plugs into the T-Connector and then you route the power wire up to the battery on your Outback Wagon. Once installed you can then use the Curt Echo # C51180 which is a wireless brake controller that you adjust the different settings with your phone.
What makes a wire pull through a conduit?
Wire-pulling compound is a non-conductive lubricant in either a gel or a slimy, soapy form that makes both the conduit and wires slick by coating the wiring, allowing it to slide through the conduit with relative ease. Apply the compound directly to the wires before pulling them into the conduit.
What kind of Hitch does a Subaru Outback use?
I recommend the Curt Trailer Hitch # CU89FR which has a hidden crosstube and then I recommend checking out Ball Mount Kit # 989900 because it includes two ball mounts, one with a 3/4” rise/2” drop and the other with a 2-3/4” rise/4” drop, a 1-7/8” hitch ball, a 2” hitch ball, and a pin and clip.
Do you need a fishtape puller to pull wire?
Unless you are pulling extremely large conductors (such as 500 kcmil), you shouldn’t need to use anything other than elbow grease or a good fishtape puller to complete the pull. Make sure your wiring does not exceed the wireway fill specified by the NEC.
What kind of wiring does a Subaru Outback use?
This particular plug-in connector provides a 4-way flat socket and is designed to be a custom wiring option for certain years of the Subaru Ascent, Forester, Outback, Crosstrek and XV Crosstrek (factory tow package required; to verify your vehicle compatibility, see application info).
How does a curt trailer wiring harness work?
A CURT custom trailer wiring harness is the easiest way to equip your vehicle with the proper electrical connection for towing a trailer. Our custom wiring offers simple, plug-and-play convenience with no cutting or splicing required, and provides a reliable connection for powering your trailer lights.
Is there a 4 pin trailer wiring harness?
This trailer wiring harness kit plugs into existing factory wiring on your vehicle and equips it with a standard, rear 4-pin trailer wiring connector for plugging in and towing a trailer STANDARD CONNECTOR.
Where is the connector on a 2020 Outback?
FYI if you are installing this in a 2020 Outback do not follow the instructions, the connector IS NOT on the drivers side by the rear seat, it is in fact on the passenger side. You do not need to remove the side panels, only the center section as if you were getting to your spare tire.