How tight should I make the serpentine belt?
The required measure of tension in the serpentine belt is that it should not deflect more than ½ inch when twisted either way from the middle. If twisted more, the belt is loose, and if twisted less, the belt is too tight. Either of the positions does not work for the vehicle.
How do you tighten a serpentine belt on a car?
If your vehicle does not have an auto tensioner, insert a pry bar or piece of wood between the alternator and the engine. Run the belt over the alternator pulley, then use the bar to pry the alternator away from the engine and increase the tension on the belt. Tighten the bolts again as you apply tension.
What happens if your serpentine belt is too loose?
If the serpentine belt is too loose, your alternator will not properly charge your battery and your accessories may not work properly. To correct the problem, tighten your belt.
What kind of pulley does a serpentine belt use?
Determine if there is a belt tensioner pulley. Depending on the application, your serpentine belt will either have tension placed on it using a movable bracket or an auto tensioner pulley. This pulley uses an internal spring to apply consistent pressure to the belt at all times.
Where do I find the serpentine belt routing diagram?
Find the serpentine belt routing diagram. Many cars come with a sticker in the engine bay that shows exactly how the serpentine belt is supposed to be routed through the various pulleys on the engine. If your vehicle does not have a sticker, you will need to find another way to remember how the belt should be run.
What’s the best way to remove a serpentine belt?
Its pulley is usually smooth while the other pulleys are grooved. The way to remove tension will be to pivot the tensioner using a tool (1) on the nut of the tensioner pulley, or (2) a special tool-lug outcropping from the tensioner or (3) in a square opening in the bracket of the tensioner pulley, cover or cap that protects the spring.
What do I need to replace serpentine belt on Dodge Ram?
Make sure the shielding around your wheels and engine is attached for full serpentine belt life. The procedure for the 5.7 Hemi engine differs from the 3.7/4.7 engines. For owners with the 5.7 liter engine, you will need a 3/8″ ratchet (preferably long-handled).
How is the tension set on a serpentine belt?
Depending on the application, your serpentine belt will either have tension placed on it using a movable bracket or an auto tensioner pulley. This pulley uses an internal spring to apply consistent pressure to the belt at all times. If your vehicle does not have a tensioner pulley, the alternator bracket is likely how tension is set on the belt.
How do you remove a belt from an auto tensioner?
Hold the tension from the belt, and slip the belt off the auto tensioner pulley to remove the belt and pulley system. Slowly release the tension to avoid damage or injury, and then remove the tool from the belt auto tensioner.