How much oil does a MaxxForce 13 blow by?
Discussion in ‘ International Forum ‘ started by trulytex, Oct 1, 2018 . I have a 2014 Maxxforce 13 with 450,000 miles. It is blowing oil out of the Blowby Tube. A couple gallons per day.
What is the jet plate on a MaxxForce 13?
The part with the brass nozzle is called the “jet plate”. Make sure you get the kit that includes it. Your other issues of oil present in the high pressure turbo outlet could indeed be a failing turbo center section. Further checks are needed, or just replace it.
Where can I find MaxxForce 11L and 13L parts?
MAINTENANCE INFORMATION GUIDE 2 – MAXXFORCE 11L & 13L •Largest North American truck dealer network •Over 9,000 technicians •9 North American Parts Distribution Centers •Top-quality parts and expert service •Unmatched 24/7 parts availability •The latest diagnostic tools E 3 – MAXXFORCE 11L & 13L NETWORK COVERAGE
What kind of warranty does MaxxForce towing have?
®11L & 13L BASIC ENGINE WARRANTY †Towing applies only for vehicles with engine-related failures and is otherwise covered for the first 90 days. With an unsurpassed B-50 rating of 1.2 million miles—engine life that helps your business go on without interruption—your MaxxForce ®engine can be counted on to show up for work every day.
How does a MaxxForce 13 oil Seperator work?
I know there are max force gurus here. The crankcase oil separator is a centrifuge type, so you are correct it is a spinner type. The spinner is driven by oil pressure. There is a small orifice the oil sprays from against a drive wheel, sorta like a water wheel.
Why is oil pouring out of the blow by tube?
This causes two problems which leads to oil pouring out of the blow by tube. 1 – due to the larger diameter, the oil spray velocity is lower, so the spinner spins slower which reduces it ability to separate oil in the first place. 2 – since the hole is bigger, more oil is spraying into the housing than what can drain away and floods the cavity.
https://www.youtube.com/watch?v=OlaeLklj2J4
Why is my MaxxForce 7 engine leaking oil?
Derating and now oil leaking! According to invoice UVC harness, 12 PIN UVC harness, crank filter, engine breather filter assembly, fuel rail pressure sensor, valve cover and/or gasket, electronic engine control sensor/regulator all replaced. Truck still derating. Oil sprays all over left side of engine.
What causes a derate on a MaxxForce 7?
You need to double check those. 100-1 is low oil pressure, 2630 is charge air cooler undercooler, or too hot of air in intake manifold. Both of these will cause derates.