How much does it cost to tighten a sway bar?
The average cost for a sway bar end link replacement – front is between $126 and $161. Labor costs are estimated between $52 and $67 while parts are priced between $74 and $94. Estimate does not include taxes and fees.
How do you tighten a sway bar on a car?
Loosen your vehicle’s front wheel lug nuts, but leave them attached to the wheels. Lift the vehicle front end with a floor jack, place jack stands under a secure part of the vehicle and lower vehicle onto the jack stands. Remove the lug nuts and the wheels. Locate the sway bar, a thin, metal bar crossing from one side of the vehicle to the other.
Do you need to alignment your sway bars?
If its just the sway bars being done and nothing else is changed or damaged, then you shouldn’t need to do an alignment. Thanks! Do I need new sway bars for both fronts? Yes, yes you do. It is most important to have new sway bars on both fronts. Thanks! Could hitting a pothole make my car’s back tires tilt inward?
How is a sway bar attached to a suspension arm?
The sway bar link is a component that attaches the sway bar to the lower control arm — the lowermost suspension arm. The lower control arm keeps the sway bar straight, while rubber bushings allow flex for ride comfort.
How to change the link on a sway bar?
Simple insert the lower part first, then the upper. Be sure it is installed the same as the original – the bushings are touching the sway bar – from the top: nut, metal washer, bushing, sway bar, bushing, metal washer. The lower link is simply nut, mounting point, smaller nut.
How do you tighten a sway bar link?
Place aftermarket sway bar link bushings on the sway bar link in the exact position the old ones were in. Aftermarket bushings have slits already cut in them, allowing you to slide them on. Tighten the sway bar link nut using a combination wrench to hold the bolt head and a torque wrench and socket to tighten the nut.
What’s the best way to repair a sway bar?
General Tips for Sway Bar Repair 1. Obtain Replacement Kit and Tools 2. Jack Up One End of Vehicle 3. Apply Penetrating Lubricant 4. Hold Sway Bar in Place 5. Use Two Wrenches 6. Cut Out Badly Damaged Links 7. Use Grease and Pliers to Replace Bushing 8. Lower Vehicle to Tighten Links
Can you remove the nut from a sway bar?
Remove the nut holding the sway bar link to the sway bar. You will have to grip the shaft below the sway bar so it does not turn – for example pair of vice grip locking pliers.The bottom bolt you can use a socket wrench on the nut, and a wrench on the nut on the other side of the mounting point (see picture). Install the new link.
How is a sway bar connected to a lower control arm?
Trace the sway bar to a sway bar link at one end, a metal component connecting the sway bar to the lower control arm. There will be one sway bar link on each end of the sway bar. Cut a vertical slit through the four rubber bushings on the sway bar link, using a utility knife.