How much does it cost to have belts replaced?
Serpentine belt replacement cost ranges between $25 and $75 on parts only; however, the cost can get much higher depending on the location of service….Typical costs.
| Vehicle | Serpentine replacement cost |
|---|---|
| Honda Civic | $80 – $99 |
| Toyota Corolla | $70 – $90 |
| Nissan Altima | $95 – $112 |
| Honda CR-V | $82 – $109 |
Do I need to replace drive belts?
Today, most serpentine belts are expected to last anywhere from 60,000 to 100,000 miles. Some belts can last significantly longer than this, while others give out before 60,000 miles. Even if you don’t notice any problems, it’s important to get the belt checked and replaced if necessary during your routine maintenance.
Can you replace your own belts?
Serpentine belt replacement is easy because today’s automatic drive belt tensioners eliminate the need to loosen bolts or pry components into position for retensioning. Just rotate the tensioner, remove the old belt and install a new one.
When should a drive belt be replaced in your car?
A drive belt is made of long-lasting rubber-based material. In most cars, a drive belt is replaced between 40,000 and 70,000 miles, however, we have seen cases where the drive belt lasted over 100k miles. What makes the belt wear sooner? Water, road dirt, excessive heat and oil leaks can cause the belt to deteriorate prematurely.
How much does it cost to replace a serpentine belt?
For just the parts, most serpentine belts retail for $15 to $45, but if you needed to hire a mechanic to replace it, then the costs could increase to anywhere from the shop minimum, often around $75 to as much as $200 if the part is difficult to access and/or install for both the parts and the professional install.
When should you replace the serpentine belt?
Most serpentine belts need to be replaced every 40,000 to 70,000 miles. If there are signs of the belt rubbing on something, make sure to identify and repair whatever it was rubbing on to avoid damaging the new belt.
How do I replace the serpentine belt?
How to Change a Serpentine Belt Step 1 – Get Out Your Cars Diagram Step 2 – Turn Off Your Car and Keep It on Idle Step 3 – Pop the Hood Step 4 – Note How the Belt Functions Step 5 – Relieve the Tensioner Pressure Step 6 – Slide the Belt Off the Pulley Step 7 – Remove the Motor Mount Step 8 – Replace the Belt Step 9 – Clean Up