How much does it cost to have a motorcycle carburetor cleaned?
Depending on the number of carbs that need to be cleaned, the costs of motorcycle carburetor cleaning can average about $100 per carb or upwards of $500 to $750 for all four. If the shop charges by the hour, this job could easily take four hours to complete.
How big is a Honda CB 750 K?
CB 750 K 1 overall length width Wheel base Seat height foot height weight suspension. R. suspension. tire Size, pressure R. R. lining fuel reserve Capacity GENERAL INFORMATION English 85.0in. in, 57-3 in. 12.2 in. 5.5 Double 5.6 in. 1.155m 218 kg Swing travel 3.25-19 Rib pattern. Disk lining swept expanding Shoe, gal. 3.3 mm) (28 psi) air air
How is the shop manual for a Honda CB750 divided?
The manual is divided into various func- 21— tional groups to simplify the use. The pages for the respective groups are indexed on this pages for convenience. Each Of the groups are further divided into section l. Description, 2. Specifications, 3, Diagnosis, ‘1. Disassembly, 5. Inspection and 6. Reassembly.
How tall are the tires on a Honda CB750?
1-3 TECHNICAL DATA Dimensional drawing e Specifications CB 750 Item Overall Length overall Width Overall Height Wheel Base Seat Height Foot Peg Height Ground Clearance Curb Weight Weight Distribution L/R Type Suspension, Travel Suspension, Travel R. F Tire Size, Type Tire Size, Type R. .
What kind of oil does a Honda CB750 use?
Front fork oil Front capacity Cylinder and ran t’ Oke 2.02x24a)in. 44.9 61.0×63.o mm 90: 1
How do you rebuild a Honda CB750 carb?
Remove all hoses from the bowls and any fuel lines from the carbs. If your bike has the vacuum-assisted petcock on it (AKA Spawn of Satan or SOS), remove it, but keep all the tubes connected to it. Start with the carbs facing down – smaller diameter ends on the table, and choke plates facing you.
What makes up a Honda CB750 Ko engine?
The shiny bits you see in this debris are tiny metal shavings from the internals of the engine such as bearing material. Some of the many parts that make up a Honda CB750 engine. Parts have been cleaned & bead blasted 1970 Honda CB750 KO engine , complete rebuild – top & bottom @ $4,500 US project current on the progress of the rebuild.
What should choke clearance be on CB750 carb?
Remove the fuel tank and set up an auxiliary tank or a long fuel line to the carbs. Remove the air cleaner to confirm proper operation of the choke butterfly valves. If the clearance between the choke valve and carb body is greater than .5mm, adjust the choke clearance by lengthening or shortening the choke lever adjustment rod.
How to sync and tune a CB750 carb?
Make sure the play in each carbs cable is the same. Turn each carb air screw until it seats, then back it out 1 full turn. Reinstall the airbox. Start the engine and warm it up to operating temperature. Remove the vacuum plug holes in each carb body and screw in the vacuum gauge adapters. Set the idling speed to 850 to 950 RPM.