How is the fuel line attached to the CARB?
Make sure the grommet is slipped over the hose before securing to the Carb, it protects the fuel line from rubbing. Underneath the van on the Nearside I connected the pre-assembled 7.3mm/reducer/5.6mm hose section to the Fuel Tank inlet.
Where do the fuel tank petcock gas line and vacumn hose go?
Where do the Fuel tank petcock gas line and vacumn hose go on the carbureters on a 1982 Kawasaki GPZ 550 H1 Canada. I am Fuel tank..Kawasaki..all hoses go from the carbs and to where i can,t…
How long do stainless steel fuel pump hoses last?
Also, the Stainless Steel hose clips will last forever. Make sure to check your fuel pump inlet size beforehand as you may need an additional length of 7.3mm hose and reducer. It was a straightforward and quick job to do.
Can you put a 5.6mm hose on a 7.3mm engine?
This meant it was impossible to fit the 5.6mm hose all the way on. My solution was to get a short length of 7.3mm hose and a metal 8mm to 6mm reducer (had to be metal so it doesn’t melt in the engine bay). The setup now looks like this:
Are there any carburetor hoses left in stock?
. Only 4 left in stock – order soon. . Only 10 left in stock – order soon. . Only 9 left in stock – order soon. . Only 20 left in stock – order soon. . . . Only 4 left in stock – order soon. . Only 4 left in stock – order soon.
What kind of fitting does a JEGS fuel inlet fit?
JEGS Carburetor Fuel Inlet AN Fitting -6… JEGS Dual Feed Fuel Line Kit Fits Holley… JEGS Carburetor Fuel Inlet AN Fittings -…
What kind of carbureted adapter do I Need?
Carbureted Adapter Fittings By Russell Performance AN Size Zinc Endura Ford, Chrysler & Early Chevy Pumps (1/2″ -6 AN 640330 640331 -8 AN 640390 – Chevy Fuel Pumps (1970 & Later) Inline F
What kind of fittings do I need for my Edelbrock Q Jets?
Holley Single Feed 600-660 Series, & All 2-Barrel Series with (9/16″ – 24 Thread) Banjo Fitting Assembles Directly to Hose. Fits Edelbrock Q-Jets for Vehicles 1966-89. Also Fits Stock Factory Q-Jets for 1974-89.