How do you reset the TPMS on a Subaru Outback?
To reset the tire pressure monitor or tpms system in your 2018 subaru outback vehicle, turn the ignition key to the “on” position and depress the tpms button, usually located under the dash, until the tpms light blinks several times.
Where is the Subaru TPMS reset button?
The TPMS reset button is usually located beneath the steering wheel.
Where is the TPMS reset button on a 2009 Subaru Outback?
To reset the TPMS warning, park the car on a flat surface and using a gauge, make sure tires are inflated to a PSI of 35 in the front and 33 PSI in the rear. With the doors locked and windows rolled up, turn the key in the ignition to the “on” position and locate the reset button below the steering wheel.
How do you relearn a TPMS on a Subaru?
Hold your dedicated TPMS tool to the tire’s sidewall within three inches of the valve stem to read all sensor IDs. After following all the prompts, connect the TPMS tool to the vehicle’s OBDII port. Your TPMS tool may prompt you to turn the vehicle’s ignition into the ON position before completing the relearn.
Why tpms light on but tires are fine?
TPMS Light stays on all the time This could either mean air pressure in one or more of your tires is low. If you have already checked and know that this isn’t the case, then it could indicate that the TPMS sensor is not reading correctly.
How do you know if you have a bad tpms sensor?
If you find that you have tires with low air pressure and there was no alert from the system, it must be because of a bad TPMS sensor. You can check your tire pressure with a tire pressure gauge to confirm that you really have a low tire pressure. Jerky steering wheel.
How do you reset the TPMS on a 2013 Subaru Outback?
Start the engine and idle for 20 minutes while the system records and stores the new PSI of each wheel. Drive the car at 25 mph or greater for another 30 minutes. If the low pressure light is still illuminated try disconnecting the battery cable and reconnecting it to restore settings.
When to clear the TPMS warning light on a Subaru Outback?
TIP: The TPMS warning light in your Subaru Outback should be cleared. However, if the light remains illuminated, keep in mind after tires are inflated/deflated, the outdoor temperature affects how fast the air in the tires will adjust to the proper temperature, this could take a day, 2 or 3, simply be patient and give the tires time to adjust.
What should the tire pressure be in a Subaru Outback?
Make sure the spare has the correct amount of air as well. F ill each tire to the recommended PSI/Air Pressure Levels. Do not forget the spare. Normally 32lbs in the Front tires and 30lbs in the Back. Drive the vehicle for 25/mph or more for a few minutes. TIP: The TPMS warning light in your Subaru Outback should be cleared.
How do you reset the TPMs on a Subaru?
Turn ignition to the ON position with the engine OFF (not the A CC position). Connect the scan tool to the OBD II port and upload the sensor I Ds. Turn the ignition to the OFF po sition. Re‐scan each sensor. Drive the vehicle above 30mph for at least 10 minutes and monit or the low tire,
What to do if your Subaru tire pressure is low?
Inspect all 4 tires for signs of damage and noticeable loss of tire pressure. The correct tire pressure for your Subaru can be found on the inside door panel. If there is visible damage and/or any tire is visibly low on air, you should change your tire or call Subaru Roadside Assistance, AAA, or another roadside service provider.