How do you reset the check engine light on a 2003 Toyota Sequoia?
While still pressing the Trip Reset Button, Turn the Ignition Key half way on where all your oil, check engine lights etc.. turn on. Don’t turn it as far as you would to normally start the car. Wait a few seconds and the Check engine light will turn off.
How do you reset the check engine light on a 2002 Toyota Sequoia?
Push and hold odometer button while turning ignition to “ON” position. HOld for about 4-5 seconds until maintenance light goes off.
Do you need a master key for a Toyota Sequoia?
If your Sequoia is other than 2003-2007, please visit this page: Try this first… Before you buy a new key for your Toyota Sequoia, first verify that you are able to enter the programming mode as described in Step 3 below. Only use your master key, because the valet key won’t work.
How to enter programming mode on a Toyota Sequoia?
*It might be very difficult to enter programming mode on Toyota Sequoia. You may have to try it several times. Open driver’s door and then insert the master key into the ignition cylinder Turn the ignition key from “Lock” to “On” 4 times within 15 seconds, but on the 5th time leave the key in “On” position
Is there a VSC warning light on my Sequoia?
I have a 2002 Sequoia – 114k miles – one owner. Dealer serviced. About three months ago I took it in for service before leaving on a weekend roadtrip – about 500 miles round trip. We stopped for gas about two hours in and when I pulled back out onto the highway, the VSC warning light began to flicker.
What is the problem with my Toyota Sequoia?
Sticking rear e-brake most likely. Having the same problem with my 02 Sequoia. Wife took it on a long road trip last weekend and had “vsc trac” indications on two different occasions. She said it beeped and from what she described, the vehicle pulled to one side. The temperatures were well above 100 degrees both days.