How do you reset emergency fuel shut off?
RESETTING THE SWITCH
- Turn the ignition switch OFF.
- Ensure that there is no fuel leaking in the engine compartment, along any of the lines or at the tank.
- If no leakage and/or odor is apparent, reset the switch by pushing the reset button on the top of the switch.
Where is the fuel shut off switch located?
Look for the fuel pump switch or inertia switch. This is a small box with a plastic button on top and an electrical connector at the bottom. On some vehicle models, this will be located in the luggage compartment. Look on a side panel for a small, round button which you can pry off with a small screwdriver.
Can a fuel shut off switch go bad?
While many fuel pump shut off switches will usually last the life of the vehicle, they can sometimes fail and cause problems with the drivability of the vehicle.
What causes a Toyota RAV4 to overheat?
Overheated Driver’s Side Power Window Master Switch: During production, the power window master switch on the driver’s side wasn’t lubricated correctly in some RAV4s. This leads to a short circuit of the switch, which may overheat or even melt the switch. Toyota issued a recall in 2015 and applied more lubricant to the switch.
Are there any recalls on the Toyota RAV4?
In 2015, Toyota recalled nearly 425,000 affected RAV4s and replaced the water diverter channel and wiper linkage at no charge. Loud Steering Intermediate Shaft Size: The steering column in some RAV4s makes a loud clunking or popping noise when turned.
What causes the fuel pump to shut off while driving?
Engine suddenly stops while driving. If the fuel pump shut off switch malfunctions while the engine is operating it may shut off the fuel pump and cause the engine to stall. The fuel pump may be reactivated by finding and pressing the reset button for the switch.
How do I reset the fuel pump shut off switch?
Push the button on the inertial switch; it should be clearly marked as the fuel pump reset, and may be in a contrasting color to the case. You may need to turn the ignition key to the on or accessory position to energize the module and reset the switch. Proceed to the next step if your inertia switch doesn’t use an external button.