How do you replace universal joints on a car?
Remove the bolts at the rear of the driveshaft. The driveshaft connects to the car with 4 bolts on its rear. Use a socket wrench to unscrew each bolt by turning them counterclockwise. Keep the bolts in a safe place so you can reinstall them later. Match the socket you use to the bolt on the driveshaft.
What’s the best way to replace a driveshaft?
Fortunately, you can do it yourself with the right tools and knowledge.First remove the driveshaft. Then pound the old U-joint out of position with a hammer. Put the new U-joint in and tap it into position. Clean and grease up the joint so it works properly. Finally, reattach the driveshaft to complete the job.
What are the universal joints on a driveshaft?
A driveshaft can be one or two pieces with a center support bearing in the middle. There are universal joints at either end of the driveshaft which act as flex joints that allow the differential to move upward when the car contacts a bump.
How does a front driveshaft connect to a differential?
There are universal joints at either end of the driveshaft which act as flex joints that allow the differential to move upward when the car contacts a bump. A front driveshaft yoke is used to connect to the transmission while a rear driveshaft flange is used to connect to the differential.
Remove the bolts at the rear of the driveshaft. The driveshaft connects to the car with 4 bolts on its rear. Use a socket wrench to unscrew each bolt by turning them counterclockwise. Keep the bolts in a safe place so you can reinstall them later. Match the socket you use to the bolt on the driveshaft.
Fortunately, you can do it yourself with the right tools and knowledge.First remove the driveshaft. Then pound the old U-joint out of position with a hammer. Put the new U-joint in and tap it into position. Clean and grease up the joint so it works properly. Finally, reattach the driveshaft to complete the job.
How do you replace a you joint on a hard drive?
Place a support under the driveshaft and tap the yoke with a hammer to break it free. The yoke is the metal piece connected to the driveshaft. The U-joint attaches the yoke to the driveshaft, so find that joint if you can’t find the yoke at first.
How do you remove retaining clips from universal joints?
Remove the retaining clips with a pair of pliers. The U-joint is held in with a clip in each of the 4 openings on the yoke. Reach into these openings with a pair of pliers and pull the clips out. A needle nose plier will help you reach the clips better.