How do you replace a rear brake disc?
Attach New Disc Place the new disc on the axle spindle and tighten with the 32mm axle nut. This nut must not be over tightened otherwise the bearing will not be able to rotate smoothly and the wheel will become seized. The notch which prevents the nut from loosen is a very useful guide to the exact required torque.
How to remove disc brake rotor from Nissan Sentra?
Position the brake caliper aside with wire. Refer to BR-41, “BRAKE CALIPER ASSEMBLY : Removal and Installation”. Do not depress the brake pedal while the brake caliper is removed. Put alignment marks (A) on the disc brake rotor and on the wheel hub and bearing. Remove the disc brake rotor.
How to remove the front wheel hub lock nut?
Refer to BRC-106, “FRONT WHEEL SENSOR : Removal and Installation”. Remove the cotter pin from the drive shaft. Remove the nut retainer from the wheel hub lock nut.
How to remove the front wheel hub on a Nissan Sentra?
Remove the brake caliper torque member bolts, leaving the brake hose attached. Position the brake caliper aside with wire. Refer to BR-41, “BRAKE CALIPER ASSEMBLY : Removal and Installation”. Do not depress the brake pedal while the brake caliper is removed. Put alignment marks (A) on the disc brake rotor and on the wheel hub and bearing.
What’s the best way to remove a brake nut?
Use your tire iron to finish removing the loosened lug nuts from their bolts. If necessary, remove the hubcap and use it as a convenient “dish” or “plate” to hold your lug nuts. When all the lug nuts are off, pull the tire away from its mounting.
Attach New Disc Place the new disc on the axle spindle and tighten with the 32mm axle nut. This nut must not be over tightened otherwise the bearing will not be able to rotate smoothly and the wheel will become seized. The notch which prevents the nut from loosen is a very useful guide to the exact required torque.
How does the foot brake work on a rear disc caliper?
connected to the parking brake linkage, has a screw setup to compensate for the fact that in normal footbrake operation, the piston automatically moves out to adjust for brake shoe lining wear. The type shown here is a common design. There is a cone behind the piston and it moves with the piston when the foot brake is applied. When the parking
Where is the adjuster screw on a brake drum?
Turn the brake drum so that the access hole is aligned with the drum’s adjuster screw. The adjuster screw is large and slotted, and is located beneath just beneath the centerline that runs horizontally across the back of the drum. Turn the adjuster screw counterclockwise until it comes to a halt.