How do you remove the seat on a 2004 Heritage Softail?
Lift the loose end of the strap over the seat and lay it down gently to prevent damaging the fender. Remove the Torx head bolt from the rear of the passenger seat. Lift the entire seat upwards slightly and pull to the rear of the motorcycle. This will disengage the seat from the catch tab below the fuel tank.
How do you change the battery on a Softail?
If your Softail uses a battery box, remove the cover by removing the screw at the bottom of the cover. Pull outward at the top of the cover to disengage the cover clip. Figure 2. This style of seat will have nuts behind the seat. Figure 3.
Where is the battery located on a Harley Davidson Softail?
The battery chart. Your battery is mounted below/beside your seat. You’ll need to remove your seat and/or battery box access cover to gain access. There are many seat options available for the Softail, but most are removed similarly. Locate the mounting nuts or bolt (s) around and under the seat.
How do you remove a battery from a Harley Davidson?
At this point, you can access the battery ground cable; disconnect it, wrap it with electrical tape, and move on. Or, you can continue to remove the battery completely. Do this by simply removing the plastic ECM mounting plate/bracket.
How do you remove battery from Sea Doo?
Once you find it, you probably want to know how to remove it properly. To remove a Sea-Doo battery, you have to locate your battery in the hull and remove the access panels first. Then disconnect the cables, always start with the negative (black) cable! Then screw off the bolts and remove the battery.
How do you change the battery on a Harley Davidson Softail?
Lift the battery straight up if it’s below the seat. You can grab onto the battery terminals with a pair of pliers if it’s difficult to remove. For side mounted batteries, pull the battery away from the bike.
When to remove the battery from a Harley Sportster?
In this quick demonstration of the Harley Sportster battery removal, you’ll learn how to remove your bike’s seat and side cover so you can check on the condition of your battery and its operating components. It is strongly recommended that you remove the negative cable of the battery first and replace it last when servicing your bike.
Do you have to remove the seat on a Harley?
You should begin every service, or repair with Harley Battery removal and Harley seat removal. The most important part would be disconnecting the battery negative cable.
How do you remove the seat on a Harley Heritage Softail?
Reinstall the nylon washer, lower the rear of the seat onto the frame and tighten the Torx head bolt to secure the seat to the fender. Lift the loose end of the seat strap over and across the seat. Secure it in place by tightening the Torx head bolt into the strap bracket on the side of the fender.