How do you remove the door panel on a 2016 Nissan Rogue?
Use a plastic automotive trim panel removal tool to gently pry off the front edge of the trim piece that surrounds the door opener handle and door lock rocker switch. Set the trim piece aside in a safe place. Then gently pry up the top edge of the trim panel that covers the door pull handle and part of the armrest.
How do you remove the door panel on a 2018 Nissan Rogue?
Lift Door Panel Off Frame Slide the plastic pry bar tool in between the bottom edge of the plastic door panel and the metal door frame. Firmly pull out the bottom edge of the door panel to release the white plastic pop rivets.
How to remove and install a Nissan Rogue?
Use two people when removing or installing the front door due to its heavy weight. When removing and installing front door assembly, support front door with a suitable tool. Remove front door finisher. Refer to INT-15, “Removal and Installation”. Remove front door vapor barrier (1). NOTE: LH side shown; RH similar.
How to adjust front door height on Nissan Rogue?
Loosen front door hinge nuts (door side). Adjust the surface height of front door according to the specifications provided. Temporarily tighten front door hinge nuts (door side). Loosen front door hinge bolts (body side). Raise front door at rear end to adjust clearance of the front door according to the specifications provided.
How to remove baffle foam from Nissan Rogue?
The front fender baffle foam adheres the front fender to the body side outer. Carefully release the baffle foam or damage to the front fender may occur. Installation is in the reverse order of removal.
What should I use to protect my Nissan Rogue?
Use protective tape or shop cloths to protect surrounding components from damage during removal and installation of hood assembly. Support the hood assembly using a suitable tool. WARNING: Bodily injury may occur if hood assembly is not supported properly when removing hood assembly.