How do you remove cable from parking brake?
Use your fingers to push the parking brake lever forward and remove the cable by taking the squared end of the cable off of the parking brake lever hook. Now, you need to get under the vehicle and trace the parking brake cable up toward the equalizer bar.
Why do I need to replace my emergency brake cable?
In this particular instance, the spring is worn out and needs replacing, and the cable itself was a bit frayed going into the sleeve that brings it to the drum. The video to the lower left shoes removing the retaining clip or washer that holds the lever into the shoe assembly.
Can a drum be removed from an emergency brake cable?
the emergency brake cable and the lever assembly without removing the drum. Also, with the outer wheel bearing removed, it allows the wheel much more play on the axle, and by tapping the drum with a hammer, you can usually get the brake shoes to retract a little, even if the cable remains jammed.
Why does my parking brake cable keep rusting?
Periodic use can break apart small rust spots or allow moisture to escape to some degree. When the parking brake isn’t used very much, the cable does not move through its insulation. If the parking brake is never used, rust can build up inside the insulation and lock the cable in place.
Use your fingers to push the parking brake lever forward and remove the cable by taking the squared end of the cable off of the parking brake lever hook. Now, you need to get under the vehicle and trace the parking brake cable up toward the equalizer bar.
In this particular instance, the spring is worn out and needs replacing, and the cable itself was a bit frayed going into the sleeve that brings it to the drum. The video to the lower left shoes removing the retaining clip or washer that holds the lever into the shoe assembly.
the emergency brake cable and the lever assembly without removing the drum. Also, with the outer wheel bearing removed, it allows the wheel much more play on the axle, and by tapping the drum with a hammer, you can usually get the brake shoes to retract a little, even if the cable remains jammed.
How do you remove a cable from a car?
You need to remove the cable by removing the two bolts holding the cable support brackets to the frame of the car. Next, you can trace the cable further up to locate the brace holding to the car. You also need to remove the bolt holding this in place which will release the cable from the car.
Allows technician to remove parking brake cable by compressing the spring. Supersedes part number 40800. Tool can be used when cable is still attached to parking brake assembly. Ends of tool are angled to allow easier access. Slots on each end allow tool to slip over cable instead of feeding the cable through the end of the tool.
When to remove and replace ABS tone rings?
Unless your CV’s are damaged, worn, or leaking, there is no reason to go any further than the tone rings. For starters, here are a few suggestions. Use the factory service manual. If for nothing else, just the torque values. Secondly USE THE TORQUE VALUES!
Where is the ABS tone ring on my LX?
My problems started with ABS, ESP, Brake, and Traction Control lights staying on and the transmission in limp mode. Only code was U1418. I found a broken tone ring on the right rear and ordered one from Modern Muscle.