How do you remove a ratchet spark plug?
3Place your spark plug socket (the big one with the rubber lining) over the spark plug; exert some pressure while turning it slightly to be sure that it’s all the way down. 4Stick the square end of your ratchet handle into the square hole in the spark plug socket. 5Loosen the spark plug by turning it counterclockwise.
What do I need to replace spark plug in Toyota Tundra?
Use the ratchet to torque the plug in by turning 1/2 a turn past hand tight. If using a torque wrench torque to 13 ft lbs. Typically all you will need is a 3/8″ drive ratchet, a 5″ ratchet extension bar, a 10mm socket, and a 5/8 inch spark plug socket. See the photos at right for more details.
How do you change the ignition coil in a Toyota Tundra?
If you need to install a new ignition coil, just slide it down into the spark plug hole. You should feel a click as it snaps onto the spark plug. Reattach and tighten the bolt. Then reconnect the electrical plug. That’s it. Now you just have to repeat these steps for the other spark plugs and coils.
How do you replace a spark plug on a Toyota 4Runner?
Use your spark plug socket plus 12″ of extension to reach the plugs. Figure 6. Apply anti-seize to the threads and check the gap before installing. Once the new spark plug is installed, do not replace the plug wire and boot. Instead, you’ll start removing this wire. Begin tracing it back.
How do you replace a spark plug in a car?
With the boot completely out, slide your spark plug socket into the hole, then unscrew the spark plug and remove. It is always highly advisable to apply some anti-seize compound onto the threads of the new spark plug before you install it. Make sure that your replacement plugs are gapped correctly.
Where is the spark plug on a Toyota Tundra?
Looking into the plug tube the spark plug is all the way down in there. Now with a 5″ extension bar and the 5/8″ spark plug socket, fit the socket over the plug and turn left to loosen. Continue loosening until the plug is free, it should be stuck in the socket and easily removable.
If you need to install a new ignition coil, just slide it down into the spark plug hole. You should feel a click as it snaps onto the spark plug. Reattach and tighten the bolt. Then reconnect the electrical plug. That’s it. Now you just have to repeat these steps for the other spark plugs and coils.
How do you put in a spark plug?
To install the spark plug, you’ll need to guide it into the hole using your ratchet and extension. Make sure that it goes in straight and start to screw it in by hand, without the ratchet handle, to insure you are not cross threading it. When it’s in place, carefully tighten it to 13 ft/lbs, or hand-tight plus a 1/4 turn.