How do you remove a belt from an engine?
Slacken the adjuster and pivot bolts, and push the pump inwards by the cast front plate until the belt is slack enough to ease off. Do not push against any other part of the pump or pipework, or you may damage it. Remove the old belt. If it is the outermost of several belts on the engine, removal is straightforward.
How do you replace the ground drive belt on a riding lawn mower?
Have a helper lift the driver seat forward and push on the idler pulley bracket while you roll the ground drive belt off the engine pulley. Release the ground drive belt from the transmission pulleys and pull the belt out of the mower. Route the new ground drive belt over the cooling fans and onto the transmission pulleys.
How to adjust and replace a power steering drive belt?
Ease the belt onto the pulley. Never try to lever off the old belt, you may damage the pulley. Slacken the adjuster and pivot bolts, and push the pump inwards by the cast front plate until the belt is slack enough to ease off. Do not push against any other part of the pump or pipework, or you may damage it. Remove the old belt.
What to do if your power steering belt is too slack?
If the belt was too slack, increase the tension by levering the pump outwards with a strong screwdriver or flat bar. Lever against the cast front end of the pump body, just behind the drive-belt pulley — not against any other part of the body or pipework, which are easily damaged.
Is there a way to replace a pump belt on a bad boy zero turn?
Is there a way to replace the pump belt (not the drive belt) on a bad boy zero turn 60″ ZT with Kohler engine without disassembling half the mower? The two jam nuts on the tension spring will decrease the belt tension. Remove belt and replace with a new one.
How do you replace pump belt on lawn mower?
You have to be able to get under the mower on the motor end with room to work. Take the belt up to one of the pulley’s and work it back and forth on the top of the pulley until it slides over the top.
Where is the pump belt tensioner on a lawn mower?
The pump belt tensioner is located under the engine and has a grease fitting at its pivot point. It is a lot easier to grease if you replace the grease fitting with a 90 degree one while the belt is off.
How do you change Hydro Oil on a lawn mower?
TO CHANGE HYDRO OIL ON COMMERCIAL MODELS, REMOVE OIL RETURN LINES FROM TOP OF HYDRO TANK AND PLACE THEM IN A DISPOSABLE OIL CONTAINER. START AND RUN MOWER UNTIL OIL LEVEL IS REDUCED DOWN TO ABOUT 2” OF OIL REMAINING IN THE TANK. DO NOT ALLOW AIR TO ENTER THE OIL LINES IN THE BOTTOM OF THE TANK.