How do you manually slide a power seat?
Locate the electric motor of the seat, which is usually at the back of the seat on the right or the left side. With the winder on your hand, turn it to the right to move your car seat backward or move the tool to the left for the seat to move forward. When you’re contented with the adjustment, remove the winder tool.
What is the seat behind the passenger seat called?
backseat
backseat Add to list Share. When you ride in the backseat of a car, you sit in the row of seats behind the driver. Kids sometimes fight over the front seat, not wanting to sit in the backseat. You can travel in the backseat of a automobile, unless you’re the driver or are riding in a two-seat sports car.
What is the passenger seat?
: the front seat of a vehicle (such as a car) where a passenger sits.
What do you call a passenger in a car?
passenger. noun. someone who travels in a motor vehicle, aircraft, train, or ship but is not the driver or one of the people who works on it.
How to remove the front seat in a Toyota Camry?
REMOVE FRONT SEATBACK COVER Remove the 2 screws and seatback board. Disengage the hook and remove the front seatback cover No. 2. w/ Side airbag: Remove the hog rings, nut and seatback cover bracket. Remove the 2 headrest supports. Remove the hog rings and seatback cover together with the pad. Remove the hog rings and seatback cover.
How to remove airbag sensor from Toyota Camry?
Driver’s seat only: REMOVE SEAT POSITION AIRBAG SENSOR Disconnect the wire harness connector. Using a torx socket wrench (T30), remove the torx bolt and airbag sensor. 17. Driver’s seat only): INSTALL SEAT POSITION AIRBAG SENSOR Temporarily install the seat position airbag sensor.
Do you have to wear safety gloves in a Toyota Camry?
Wear safety gloves, because the sharp surfaces of the seatback frame and seat adjuster may injure your hand. Work must be started more than 90 seconds after the ignition switch is turned to the LOCK position and the negative (−) terminal cable is disconnected from the battery. (The SRS is equipped with a back−up power source.
What’s the clearance between the seat and the rail?
HINT: Be sure to maintain a clearance between the seat position airbag sensor and the seat rail is within 0.6 mm (0.023 in.) to 2 mm (0.079 in.). Push the top of the sensor. While holding the sensor, tighten the sensor using a torx socket wrench (T30).