How do you fill up a transfer case?
The transfer case does not have a dipstick to check fluid level. It is basically “fill till you spill.†Using either the fluid bottle top or syringe, fill the fluid into the filler plug hole until fluid runs out of it. Step 3: Clean up. Reinstall the fluid fill plug. Wipe any excess fluid from the transfer case.
How do you change the fluid in a transfer case?
Step 2: Refill the transfer case. The transfer case does not have a dipstick to check fluid level. It is basically “fill till you spill.†Using either the fluid bottle top or syringe, fill the fluid into the filler plug hole until fluid runs out of it. Step 3: Clean up. Reinstall the fluid fill plug.
How do you replace a transfer case output shaft?
Slide under the vehicle and locate the transfer case output shaft. Step 3: Pry out the drive shaft. If you have a front slip yoke drive shaft, remove the bolts to the drive shaft on the rear axle. Use a large flat screwdriver and slightly pry out the drive shaft and universal joint from the yoke on the axle.
Why is it important to have a transfer case?
Difficulty in shifting gears: The seal which keeps the fluid inside the transfer case is very important for an operation which is smooth of the transmission of the vehicle. When there is a leak in the fluid due to a broken seal, it ends up reducing the fluid volume which is working in the transmission currently.
How do you rebuild a transfer case?
How to Rebuild a Transfer Case Step 1 – Purchase Transfer Case Rebuild Kit Step 2 – Raise and Secure the Vehicle Step 3 – Remove Skip Plate Step 4 – Drain Transfer Case Fluid Step 5 – Removing the Transfer Case Step 6 – Open Transfer Case Step 7 – Remove Parts to Be Replaced Step 8 – Install New Parts Step 9 – Close Up Transfer Case
How do you remove transfer case?
Drain the transfer case fluid. Remove the driveshaft. Remove the right wheel halfshaft. Remove the intermediate shaft. Remove the retainer ring from the stub shaft for tool installation. Discard the used retainer ring. Remove the stub shaft using a slide hammer and adapter. Remove the transfer case mounting bracket.
Do I need a new transfer case?
Here are some of the ways you can tell you might need a new transfer case. You’re hearing strange sounds emanating from underneath your vehicle. If you hear sounds coming from underneath your vehicle, they could be coming from almost anywhere. But many times, it could be your transfer case that’s to blame for them.
How much does a transfer case cost?
The average cost for a transfer case replacement is between $2389 and $2500.