How do you do the Paperclip power supply test?
Once the paper clip has been attached to the green and black wires, this will enable the power supply to turn on while it is disconnected from the motherboard something not possible, otherwise. After this is done, turn off the power switch, if one is present, and connect the power cord to the PSU as shown below:
What is the paper clip test on a motherboard?
This test is called, “The PSU Paper Clip Test.” The first things we need to identify are the main power connectors that run from the PSU and attach to the motherboard to supply the voltage and current that your motherboard and its components need.
How to test the bend of a paper clip?
For the 90º bend, test the paper clip using the following procedure. Use a similar procedure for the 180º and 45º tests. Note that the paper clips used in this example are Jumbo paper clips that are capable of repeated bending. Different paper clips will yield different results.
How is the acceleration of a paper clip determined?
Assume that the use cycle is a 45º bend. The acceleration stress is determined to be the angle to which the paper clip is bent. In this case, assume that the two accelerated bend stresses are 90º and 180º. For the 90º bend, test the paper clip using the following procedure.
How can I test my power supply with a paperclip?
Flip the switch on the back of your power supply to the off position “0” 3. On the 24 Pin connector locate the green wire** going into pin 16 (see diagram below for pin numbering) 4. Insert one end of the paperclip into the pin 16 5.
This test is called, “The PSU Paper Clip Test.” The first things we need to identify are the main power connectors that run from the PSU and attach to the motherboard to supply the voltage and current that your motherboard and its components need.
Where is the green wire on a PSU paper clip?
To perform the PSU Paper Clip test, we’ll need to examine the power supply connectors closely and find the one that has a lone green wire. Ninety nine percent of the time, this green wire is located on pin 14 on the bigger connector. In addition to the green wire, locate the other black wires that are present in the connector.
When to do the PSU paper clip test?
If your system appears to be exhibiting an, abnormally, high temperature and you suspect that the PSU’s fan has gone bad but are not sure, there is a test you can perform which should prove weather the fan is working or not. This test is called, “The PSU Paper Clip Test.”