How do you clear a DSC alarm problem?
How to Reset a DSC Alarm After the Power Has Been Off
- Open the access door on the unit.
- Press and hold the “RESET” key for 2 seconds.
- Press the buttons “*72” if the alarm does not reset after pressing the RESET button.
- Check the sensors if it still does not turn off.
How do I reset my alarm system?
You can reset your alarm system by powering it down and then powering it back on. This is what is known as a power reset. To power down the system, the backup battery must be disconnected, and the transformer must be unplugged. Then reconnect the battery and transformer to power it back on.
Why is my DSC alarm system beeping?
If your DSC home alarm is beeping due to this condition, the main panel battery is low or failing. If you’ve recently had a power outage, wait 24-48 hours after power is restored. If the beeping persists, the battery probably needs to be replaced. The battery can be replaced by your alarm company, if you have one.
How do I change my alarm code?
Depending on the type of home security system is installed in your house you will need to either press the “Reset” button or “#9” on the keypad. When prompted (usually by three beeps) enter your current alarm code followed by “#” and then the master code.
How do I reset my home alarm after changing the battery?
Step-by-Step Guidance
- Find your security system status button.
- Find the manufacturer’s website for install instructions.
- Locate the power source to the main control panel.
- Disconnect back-up battery.
- Leave power off for a minimum of 5 minutes.
- Reconnect battery leads.
- Press keys (*) (#) at the same time.
- Key in your code.
How to test, clean, and maintain your alarms?
Our alarms are designed to be as maintenance-free as possible. There are a few things you can do to make sure the alarms work their best for a long time. Testing with the “Test” button helps ensure that your alarms have a reliable power source. While wearing ear protection, press the Test/Silence button until you hear the test sequence.
When does the maintenance required light come on?
Every time you start the car, the maintenance required light will turn on for about six seconds to test the bulb, and then go out. A flashing maintenance required light comes on after 4,500 miles. This is an alert for you to make an appointment for car service because you are getting close to the 5,000-mile service interval.
What’s the difference between a check engine light and maintenance required light?
Unlike a check engine light, a maintenance required light is based strictly on a car’s mileage and when the light was previously reset. A qualified service technician can diagnose the car’s maintenance needs and provide the necessary services, such as changing the engine oil and oil filter or providing a general vehicle inspection.
How can I Reset my GM theft deterrent alarm?
If anything else is open, the alarm will not be reset. Close the door and wait for the security light to stop flashing from inside the car. Another option is to close the doors first, and then press the “Lock” button on the keyless remote. This will also pre-arm the theft-deterrent alarm system.