How do you adjust high beam headlights?
Using the alignment mechanisms in your vehicle, adjust one headlight vertically until the Alignment Point is even with the X axis. 8. On the same headlight, adjust horizontally until the Alignment Point is even with the Y axis.
Where are your high beam controls located?
High beams, also called “main beams,” are mostly used in rural areas, highways, and other roads where there’s less traffic. Headlight controls are found either on your dashboard or on the left stalk toggle switch of your steering wheel.
When should you not use high-beam headlights?
Never use your high-beam headlights while you are driving in fog, rain, or snow. In such conditions, they can make your vision even worse. High beams will shine directly into the fog or precipitation, which will reflect the bright light back to you.
How do you remove headlight adjustment screws?
Use a screwdriver to pull the adjuster out if it is broken. Once the cover is off of the headlight assembly, you will see the exposed adjuster screws sticking up from the base. Rotate them counterclockwise with a Phillips screwdriver to remove them. Pull out the plastic cap covering the base of each screw as well.
Where are the adjustment screws on a headlight?
The first thing you need to do is locate the adjustment screws on your vehicle. In many cases, it will be necessary to remove the trim ring from the headlight. Most adjustment screws are located on the top and side of the light housing. They should be clearly marked. If you cannot locate the screws, check your owner’s manual.
Where are the headlight bolts on a car?
You can then follow these steps: Step 1: Park your car on level ground facing a wall. Step 2: Locate the headlight adjustment bolts or screws. These are located on the top of the headlights and on the inboard side of the headlight housing.
How to adjust your car’s headlights-AutoZone?
How to Adjust Your Car’s Headlights 1. Before adjusting your headlights, make sure the car is level. This means checking the tire pressure and removing any… 2. Now that the car is level, turn on the headlights. Just use the low beams, not the high beams or fog lights, as those… 3. Use a tape
How can I check the alignment of my headlights?
It is fairly simple to check the alignment of your lights. All you need is a flat surface, a wall to project the lights on, a tape measure, a carpenter’s level, screwdriver and some tape. Here are step-by-step directions on how to verify your lights are aligned. Step 1: Prepare the car.