How do I disable mini start stop?
The traditional approach: Know, if you don’t already know it, that there is a start and stop disable button on your center console (depending on the year of your car you may have a button labeled “ECO”, “Start and Stop” or “S&S”) that you can use to disconnect your start and stop on every begin.
Do MINIs have spare wheels?
IIRC the new Mini doesn’t have a spare wheel.
How do you remove the subframe on a Mini Cooper?
Remove the 16mm bolt securing the lower engine mount to the subframe. Shown here is one of the two mounting plates that hold the rear of the subframe to the car.
Where is the U-joint connector on a Mini Cooper?
The u-joint connector for the steering shaft is located inside the car, behind the pedals. Remove the pinch bolt from the steering coupler before lowering the subframe Carefully lower the subframe enough so you can remove the electrical connectors to the steering rack. Thee connectors must be unplugged before lowering the subframe completely
How to remove crush tube from Mini Cooper?
Shown here are the two crush tubes with the bumper cover and bumper carrier removed (green arrows). Remove the two large bolts holding the crush tubes to the front of the subframe and pull the tubes off. Also don’t forget to remove the 10mm bolts at the front holding the crush tube to the plastic support frame.
Where are the radiator brackets on a Mini Cooper?
Begin by removing the front bumper and bumper brackets (Refer to our article R55/R56/R57 Radiator Service Position for more info). The u-joint connector for the steering shaft is located inside the car, behind the pedals.
Remove the 16mm bolt securing the lower engine mount to the subframe. Shown here is one of the two mounting plates that hold the rear of the subframe to the car.
Where are the heater controls on a Mini Cooper?
Revised heater design (same as used on later Leyland Minis), however, in 1971, the heater controls were located on the lower dash rail between the steering wheel and driver’s door (example provided in images). Revised choke cable position on right hand side of steering wheel (to the left of the heater controls).
What kind of Windows did Mini Coopers have?
Front quarter windows and wind up windows applied to all Australian Cooper S cars. Door handles on all 1969 – 1970 Australian Minis, including the MK2 Cooper S, had a small rubber stop at the end of the handle for pedestrian safety.
The u-joint connector for the steering shaft is located inside the car, behind the pedals. Remove the pinch bolt from the steering coupler before lowering the subframe Carefully lower the subframe enough so you can remove the electrical connectors to the steering rack. Thee connectors must be unplugged before lowering the subframe completely