How do I connect my AfterShokz Bluez 2?
How do I pair Bluez 2S to my device?
- Start with your headphones off.
- Enter pairing mode by pressing and holding the power button for 5-7 seconds, until the LED light flashes red and blue.
- Open your device’s Bluetooth settings and select the Bluez 2S. Audrey will say “Connected.”
How do I know when my AfterShokz is fully charged?
The LED light on the headphones will be red if the headphones need charging, and blue when the headphones have fully charged. You can also check battery status by powering on your headphones and clicking volume+ or volume-. Audrey will say “Battery High,” “Battery Medium,” “Battery Low” or “Charge Me.”
How do I reset my AfterShokz headphones?
Press and hold the multifunction button, volume+ button and volume- button simultaneously for 3-5 seconds. You’ll hear beeps and/or feel vibrations. Turn your headphones off. Your headphones are now reset and can be re-paired to your device.
How long do AfterShokz take to charge?
1.5 – 2 hours
The AfterShokz Bluez 2S takes 1.5 – 2 hours to charge from 0 to 100 percent. They come out of the box at approximately 50 percent charged. How do I turn my headphones on? To turn your headphones on, press and hold the power button for 5-7 seconds.
How do I pair my AfterShokz as500?
Locate the Bluetooth menu on the device and select “AfterShokz”. – If Bluez is pairing with a device for the first time, it will enter the pairing mode automatically. The LED indicator will flash blue/red. – Bluez will automatically reconnect with a device that was previously paired in approximately 5 seconds.
How do I check my AfterShokz battery?
You can avoid this annoying situation by remembering to check your headphone’s battery status. To check the battery status, pause your music and click the volume+ or volume- button. Audrey will say battery high, battery medium, battery low, or charge me.
Can you use AfterShokz while charging?
Yes, Trekz Titanium can be used while they’re charging.
Why are my AfterShokz not turning on?
You can perform a manual reset on your headphones by following these instructions: Start with your headphones off. Enter pairing mode by pressing and holding the volume+ button for 5-7 seconds. Press and hold the multifunction button, volume+ button and volume- button simultaneously for 3-5 seconds.
Why are my AfterShokz blinking red and blue?
My headphone mic is picking up too much ambient noise. Enter pairing mode by pressing and holding the volume+ button for 5-7 seconds. Your headphones will turn on, and then the LED light will flash red and blue.
Can I use my AfterShokz while charging?
Hello – AfterShokz here. Yes, Trekz Titanium can be used while they’re charging.
What is the button on the side of my AfterShokz headphones?
All AfterShokz wireless Bluetooth headphones include a multi-function button. It’s located on the outside of your headphone’s left transducer. The multi-function button is essentially your personal assistant built into your headphones.
How do I make my AfterShokz louder?
Click the volume+ or volume- buttons to increase or decrease volume levels.