How do I complete a Nissan Xterra drive cycle?

How do I complete a Nissan Xterra drive cycle?

Follow the OBD II Drive Cycle below in order to set your Nissan’s emission monitors. This OBDII drive cycle begins with a cold start (coolant temperature below 122 degrees F). We recommend achieving this by allowing the vehicle to cool down overnight, and beginning the drive cycle process the following day.

Why did my Nissan Xterra not pass smog?

I have a 2003 Nissan Xterra that did not pass smog. The print out stated that the check engine light was on and that is why it failed. However, the check engine light is not on-nor any other indicator lights. The smog guy said it was because I put in a new battery and the computer wasn’t “synched” yet.

How to set the emission monitor on a Nissan Xterra?

Follow the OBD II Drive Cycle below in order to set your Nissan’s emission monitors. This OBDII drive cycle begins with a cold start (coolant temperature below 122 degrees F).



Why was my drive cycle not completed by Nissan?

THEY WERE UNABLE TO PERFORM/COMPLETE THE TEST DUE TO THE FACT THAT MY OBD WAS “NOT READY”. I DIDN’T FAIL, MORE LIKE AN INCOMPLETE. APPARENTLY THIS WAS BECAUSE I HAD THE BATTERY DISCONNECTED AND HAD NOT DRIVEN/STARTED THE ENGINE FOR SOME PERIOD WHILE DOING SOME RECENT UPKEEP/REPAIRS (NONE OF WHICH INVOLVED THE EMMISSION SYSTEM).

How much does a Nissan Drive cycle cost?

ONE DEALERSHIP SAID THAT BECAUSE IT WAS A “LENGTHY PROCESS”, THAT I COULD ALWAYS COME IN, AND THAT FOR $250, A TECH COULD RUN THROUGH THE DRIVE CYCLE IN A FEW HOURS TIME FOR ME! SO MUCH FOR THAT. I AM STILL UNSURE EXACTLY WHAT MY DRIVE CYCLE IS.

How often should you turn off the engine in a Nissan?

EVERYTHING RANGING FROM “30-40 MIN’S OF FREEWAY DRIVING SHOULD DO THE TRICK”, TO NEEDING TO DRIVE “50 MILES OF REGULAR STOP-AND-GO AND 75 MILES OF FREEWAY.” I WAS EVEN TOLD THAT I NEEDED TO “TURN THE ENGINE OFF THREE (3) TIMES DURING A 20 MILE STRETCH OF FREEWAYING (60MPH+).”

Follow the OBD II Drive Cycle below in order to set your Nissan’s emission monitors. This OBDII drive cycle begins with a cold start (coolant temperature below 122 degrees F). We recommend achieving this by allowing the vehicle to cool down overnight, and beginning the drive cycle process the following day.

What’s the problem with my 2003 Nissan Xterra?

2003 NISSAN Xterra Problem started a couple of days ago. While driving the car normally it suddenly stopped. I was able to restart it but it turned off again 60 seconds later.

Is the Nissan Xterra a good car to buy?

Edmunds’ expert review of the Used 2006 Nissan Xterra provides the latest look at trim-level features and specs, performance, safety, and comfort. At Edmunds we drive every car we review, performing road tests and competitor comparisons to help you find your perfect car. Read the full in-depth review of the Used 2006 Xterra at Edmunds.

What’s the price of a 2006 Nissan Xterra?

For 2006, it comes in four trim levels, X, S, Off Road and SE. The entry-level “X” model is new, and lowers the Xterra’s base price to under $20K, but that’s for a two-wheel-drive stripper with crank windows, manual mirrors and 16-inch steel wheels. Four-wheel drive adds another $2 grand.

What is the idle relearn procedure for a Nissan?

Battery voltage must be more than 12.9 V engine running at idle Electric load switches OFF. That means no A/C, headlamp, rear window defogger If you have daytime running lights (DRL) do this procedure to shut them off: BEFORE starting the engine: Apply the parking brake, or set the lighting switch to the 1st position.

Follow the OBD II Drive Cycle below in order to set your Nissan’s emission monitors. This OBDII drive cycle begins with a cold start (coolant temperature below 122 degrees F).

I have a 2003 Nissan Xterra that did not pass smog. The print out stated that the check engine light was on and that is why it failed. However, the check engine light is not on-nor any other indicator lights. The smog guy said it was because I put in a new battery and the computer wasn’t “synched” yet.

Battery voltage must be more than 12.9 V engine running at idle Electric load switches OFF. That means no A/C, headlamp, rear window defogger If you have daytime running lights (DRL) do this procedure to shut them off: BEFORE starting the engine: Apply the parking brake, or set the lighting switch to the 1st position.