How can I tell if my Harley Davidson has a fuel problem?
Check for intake gasket leak. Spray wd-40 around intake at jugs.See if you get any change in rpm. Could this be a venting problem? Once the engine starts to sputter how long before you can start it and have it run another mile?
What should I do if my fuel injected Harley wont start?
On fuel injected models, make sure that you can hear the fuel pump cycle when switched to RUN. If not, check your fuses. As always, the best way to avoid being stranded with your Harley Davidson is to be diligent about your bike’s maintenance.
What are the most common problems with a Harley Davidson?
Fuel System Failures Vapor lock malfunctions, fuel injectors, and defective pressure gauges are among the most reported problems with a Harley’s fuel system. These problems can be costly and difficult to repair. Complete regular maintenance checks on the fuel system to guarantee that it’s running properly. 6. Accessories
What kind of fuel does a Harley Davidson use?
I have a 2002 Roadking Fuel Injected,with 16000 miles, that acts like it is starving for fuel. The first mile I drive there is no problem, but then it starts to sputter and act like a clogged filter. It idles fine. I removed the fuel pump and checked the lines and the filter sock. No visible cracks and the sock was clean.
Check for intake gasket leak. Spray wd-40 around intake at jugs.See if you get any change in rpm. Could this be a venting problem? Once the engine starts to sputter how long before you can start it and have it run another mile?
How often does a Harley Davidson engine fail?
This metal-to-metal contact promotes engine failures which can be dangerous to you and your bike. This problem can occur anywhere from 15,000 to 75,000 miles depending on the severity. The only way to truly avoid this problem is to completely swap out the chain system for a gear-driven system.
How do you test a Harley ignition coil?
Things you will need to perform the test – SAE wrench set and an Ohmmeter. Turn off your bike and wait until the engine becomes cool enough to touch. With your hands, disconnect the plug wires off the coil. You need to use an SAE wrench to unscrew the small connections.
How can I test for Triger on my Harley Davidson?
Use a couple jumper wires 10 inches long so you can test for a triger signal with a test light or a spare turn signal lamp. Start the engine, it should flash. If you can hold the jumper wires tight in the connector and wiggle your repair area to see if it changes the flash pattern.
When do you get a check engine light on a Harley Davidson?
If you own and ride Harley Davidson motorcycles, you may get a check engine light from time to time. It is inevitable. A check engine light can appear for a variety of issues, and rarely is it serious.
Things you will need to perform the test – SAE wrench set and an Ohmmeter. Turn off your bike and wait until the engine becomes cool enough to touch. With your hands, disconnect the plug wires off the coil. You need to use an SAE wrench to unscrew the small connections.
How to test no spark on Harley Davidson?
Test each of these (C & D) to terminal (A) for the primary side ohm test. You can also do a volt test to the first (A) terminal by testing the voltage on it after the key is turned on for 2 seconds. It should read 12 volts to grd. If it doesn’t then you have to go deeper into the codes thrown.
What kind of ohm test does a dual coil Harley Davidson do?
The second (B) being the ION sensor (anti knock thing I think), just leave it out of the test. If you have a dual coil you will have 2 more (C & D) terminals. Test each of these (C & D) to terminal (A) for the primary side ohm test.