Does crankshaft pulley move freely?
The camshaft and crankshaft pulleys are directly attached to the engine (camshaft and crankshaft) and will only rotate if the engine is running or manually rotating the engine by placing a socket and breaker bar to the crankshaft pulley bolt.
How do I know if my harmonic balancer has slipped?
Re: Harmonic balancer / how to check if it’s slipped The mark is chiseled across between the center hub and the outer ring. Rotate the engine with a 3/4 wrench and look closely for the mark. If the mark on the hub is not aligned with the mark on the ring then it is slipped.
How do I know if my vibration damper is bad?
Bad Harmonic Balancer: Signs to Watch Out For
- Engine Vibrations. The harmonic balancer’s job is to dampen vibrations applied to the crankshaft.
- Noticeable Harmonic Balancer Wobble.
- Unusual Noises.
- Illuminated Check Engine Light.
- Visible Wear or Damage.
How do you turn a crank pulley on a Tacoma truck?
Use the 22mm socket to turn the crank pulley so that the 2 holes are lined up vertically. With your pulley holder tool set up, get under the truck and pass the handle end towards the opening on the passenger fenderwell. Lay the handle on top of the frame.
How do you remove a pulley from a crank pulley?
Lay the handle on top of the frame. Place the tool behind all the fluid lines except the one you removed the 10mm bolt to. The tool goes in front of this line. You can move the larger fluid line closest to the pulley out of the way since you removed the bolt.
Where to put a pulley holder on a truck?
With your pulley holder tool set up, get under the truck and pass the handle end towards the opening on the passenger fenderwell. Lay the handle on top of the frame. Place the tool behind all the fluid lines except the one you removed the 10mm bolt to. The tool goes in front of this line.
https://www.youtube.com/watch?v=k_RdCWQhoXA