Do you need a special tool to change fuel filter?
Changing your fuel filter typically requires only some simple tools like wrenches, sockets, screwdrivers and pliers. Of course, the specific tools you’ll need depend on the way your fuel filter is attached to the fuel lines. If the filter is connected with clips, you may only need a pair of pliers to get the job done.
Where is the fuel filter on a 1986 Toyota 4runner?
More specifically, its underneath the intake tubes and above the starter. There is also a small filter in the tank.
Where is the fuel filter on a 1986 Toyota Camry?
The fuel filter should be located just below to the right of the air filter box. this is in the right side of the engine compartment. to change the fuel filter you must remove the air filter box. the top fitting is a banjo fitting and the bottom fitting is a standard screw in flared fitting.
Do you have to replace the fuel filter on a Toyota 4Runner?
If you have ever had a fuel filter clog up and the flow of fuel stop, you know that you are not going anywhere. Toyota claims that the OEM fuel filter does not have to be replaced until you replace the engine. Once you see where the filter is located on a four cylinder engine, that is comforting since it can hardly be seen.
How do you remove a fuel line nut?
Locate the fuel filter under the driver’s door, along the frame rail. Then, use your wrench to remove the two fuel line nuts on each side of the filter. Pull the lines off, then remove the two bolts holding the filter in place. Figure 3. Disconnect two line nuts and two bolts on top.
How do you change the fuel filter on a banjo?
Hold the 17mm nut on one end, the filter with an open end wrench, and then use a 14mm socket to loosen the banjo fitting. It will be tight with little room to work. Fuel will leak when the fitting is loosened. Then, do the same to the other end of the filter. Access mounting bolts from the passenger wheel well.