Can you tighten a spring?
You can’t. Or at least, you can’t compress it back to it’s original size and expect it to maintain the same strength. Stretching springs is a bad idea in general.
How does a recoil work on a snowmobile?
Recoils contain small parts that are under a lot of tension. Place the recoil on a flat work surface with the guts facing up. If the rope is still intact and is under spring tension, let the rope pull through the hole in the housing and inside the recoil as far as possible while holding the rope.
What to do if your snowmobile recoil starter is not working?
Make sure the knot in the rope located in the reel lines up with the hole in the recoil housing when the rope is fully extended. If not, the coil might bind and cause damage. If the knot and hole don’t line up, go back to Step 10 and start over.
How long does it take to repair recoil on Arctic Cat snowmobile?
Once you can make the repair, follow these steps. The whole job should take about one hour. We repaired a recoil from an Arctic Cat for this story, however design and construction is similar among all manufacturers. Variations exist among the components, but they perform the same function and the principles apply across the board.
What do you need to know about recoils?
Inspect the mounting holes on the recoil housing for cracks or other damage. If cracks are severe, the housing might need to be replaced. Before you start to disassemble the recoil, put on a pair of safety glasses. Recoils contain small parts that are under a lot of tension. Place the recoil on a flat work surface with the guts facing up.
How do you test recoil on snowmobile?
Test recoil operation before installing on the engine. Make sure the knot in the rope located in the reel lines up with the hole in the recoil housing when the rope is fully extended. If not, the coil might bind and cause damage. If the knot and hole don’t line up, go back to Step 10 and start over.
Once you can make the repair, follow these steps. The whole job should take about one hour. We repaired a recoil from an Arctic Cat for this story, however design and construction is similar among all manufacturers. Variations exist among the components, but they perform the same function and the principles apply across the board.
Inspect the mounting holes on the recoil housing for cracks or other damage. If cracks are severe, the housing might need to be replaced. Before you start to disassemble the recoil, put on a pair of safety glasses. Recoils contain small parts that are under a lot of tension. Place the recoil on a flat work surface with the guts facing up.
What causes spring to pop out of snowmobile?
Inspect the tabs of the reel to make sure they aren’t worn, cracked or broken. The spring may have a broken hook on the end, or it might have popped out of position, which is usually caused by a worn part. Replace components that are damaged, and start the assembly process.