Are there any problems with the Mazda3 transmission?
Mazda MAZDA3 owners have reported 5 problems related to transmission stuck in gear (under the power train category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Mazda MAZDA3 based on all problems reported for the MAZDA3.
Are there any problems with the 2007 Mazda 3?
See all problems of the 2007 Mazda MAZDA3 . When driving on the highway, the transmission of my 2004 Mazda 3 with only 84,000km died as it lost the ability to reach 3rd and 4th gear. This incident nearly cost me my life yet Mazda canada would do nothing about it.
Why does my Mazda 3 not start when parked?
The starter itself or a starter solenoid may be faulty. A problem with a neutral safety switch. If a car does not start with the transmission parked, but starts in neutral, it may be due to a problem with a neutral safety switch or the shift lever cable.
How often do you change the transmision fluid on a Mazda 3?
Well part of the problem could be the 47,xxx miles with no tranny service. I could careless what Mazda claims, if you have an automatic transmision it NEEDS the fluid replaced every 30k miles, and the Mazda 3 trans is worse then many in how bad the fluid gets.
Mazda MAZDA3 owners have reported 5 problems related to transmission stuck in gear (under the power train category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Mazda MAZDA3 based on all problems reported for the MAZDA3.
The starter itself or a starter solenoid may be faulty. A problem with a neutral safety switch. If a car does not start with the transmission parked, but starts in neutral, it may be due to a problem with a neutral safety switch or the shift lever cable.
Why does my Mazda not start when I Turn on the ignition?
If when you turn on the ignition, the “Security” light stays on or flashes, it means that your car’s security system does not recognize the key or that there is a problem with some parts of the security system itself. Sometimes the key just needs to be reprogrammed.
Where is the ignition switch on a Mazda 3?
An ignition switch is an electrical switch installed on the rear of the ignition lock mechanism. If shaking the key in the ignition switch helps to start the car, you should check the ignition switch first. The starter solenoid control wire may have a bad connection.
Why is my Mazda 3 stuck in gear?
This is so dangerous. See all problems of the 2007 Mazda MAZDA3 . Nearly every time while driving, a yellow “at” sign will appear as the gear will jump from whatever it is to 3, causing a sudden, sharp jerk (as if one suddenly braked), before going back to whatever gear it was in.
Are there any overdrive problems with Mazda cars?
Effects. Overdrive problems with Mazda vehicles can be difficult to detect unless you are consistently driving long distances in which the top gear is frequently used, such as on the highway. The effects of defective overdrives, however, can lead to engine damage and less efficient gas mileage, so it is important to address any suspicions promptly.
What happens when your transmission gets stuck in 3rd gear?
The car can also go into “limp mode”, in which the gear gets stuck in 3rd for a period of time (usually 2 minutes to until restarting the car). All of these are extremely dangerous for the driver and drivers around them, as the car may suddenly stop or speed up with zero warning to anyone.
This is so dangerous. See all problems of the 2007 Mazda MAZDA3 . Nearly every time while driving, a yellow “at” sign will appear as the gear will jump from whatever it is to 3, causing a sudden, sharp jerk (as if one suddenly braked), before going back to whatever gear it was in.
Are there any transmission problems with the Mazda 626?
Mazda vehicles were notorious for automatic transmission problems in the early 2000s, especially the 626, Millenia, and MPV models. From 2005 to 2020, Mazda automatic transmissions in Mazda 3, 5, 6, CX-7, CX-9 have been very reliable with very few transmission issues. That doesn’t mean that Mazda transmissions never fail.
Can a Mazda 5f31j fail to engage reverse gear?
There will be a P0708 code stored in the memory. Replacing the switch solves the issues. Loose connector on the neutral safety switch or damaged wiring. Performing a visual check will reveal potential issues. Mazda MPV models that use a 5F31J 5-speed transverse automatic transmission can fail to engage reverse gear.