Are there aftermarket brake and clutch levers on sale?

Sale 20% Off! Exact Fit parts are designed specifically for your bike. . . Exact Fit parts are designed specifically for your bike. . Exact Fit parts are designed specifically for your bike. . . Exact Fit parts are designed specifically for your bike. . . Exact Fit parts are designed specifically for your bike. . .

What to do if your handlebar levers get bent?

Don’t bother with trying to repair your bent levers by heating them up with a blow torch and then straightening them up at the vice, because in this case the part can get overheated and snapped off. The components offered in the aftermarket are produced from durable metals and their alloys while being budget-friendly.

When to replace the release bearing on a clutch?

Always replace the throwout bearing whenever the clutch is removed for service. A faulty release bearing will make more noise when a load is applied, such as when the clutch pedal is depressed. Clutch forks take a lot of abuse. Inspect the entire clutch fork for signs of cracking, distress and metal fatigue.

Why is the push rod on my clutch pedal not working?

The push rod connects the top of the clutch pedal to the piston inside the master cylinder. If this rod were to bend, it may not travel smoothly through the clutch master cylinder. While this is not a common issue, it’s possible for the push rod to bend while replacing another component, such as the clutch pedal assembly or master cylinder.

What kind of clutch plate does Husqvarna use?

Husqvarna good used gear shaft seal flange behind drive sprocket part number 1610938-01 to fit 1969 to 1979. Husqvarna clutch plate kit part number 1611108-01 = 6 plain plates, 1611109-01 = 5 plates with lining, to fit 250/360/400/450/460 1972 to 1975. LIBRARY PHOTO Husqvarna good used 1987 cr petrol tank. Part number 1513801-01

What was the front brake plate on a Husqvarna?

Husqvarna used front brake plate part number 1516663-01 1975 to 1976, brake plate only. Husqvarna nos new old stock sprocket part number 1612946-01, 12 teeth fits early small tappered shaft upto 1968. Husqvarna gearbox bearing part number 2931240-04, fits all upto and including 1979. Fits behind final drive sprocket on sprocket shaft.

What kind of clutch lever does a Kawasaki Vulcan use?

Only 5 left in stock – order soon. i5 Chrome Skull Front Brake & Clutch Levers for Kawasaki Vulcan EN 500 VN 800 900 2000 Classic Custom Drifter LT 1990-2020. . . Only 4 left in stock – order soon.

How to replace a clutch lever on a motorcycle?

1. The procedure to remove your clutch lever will vary depending on your bike but if you follow your nose you should be able to get it out. If you’re having trouble, consult your service manual. Just make sure you put aside all the screws, nuts and bolts as you’ll need to reuse them all. 2.

Navigation