How do I identify a Dana 44 rear axle?
Many Dana axles have the model ID cast into the fins or centersection. Look for a “44” or “60” cast into the reinforcement ribs. The number can usually be found on the lower right side rib below the differential cover, but it may also be found on other ribs or on top of the main cast structure.
What kind of axle does a jeep Dana use?
To get an idea of the whole differential end to end, here’s a TeraFlex Tera 30 Heavy Duty Front Replacement Axle Housing (Part TF-3503004). Note how the ends are made to accept spindles. The Dana 44 has been used on the front and rear of Jeeps.
How can you tell the difference between a Dana 35 and a Dana 44?
The easiest way to tell these axles apart is to look at the shape of the differential cover. The Dana 35 cover is pretty much perfectly round. The Dana 44 is sort of a six-sided shape. A Dana 35 (left) compared to a Dana 44 (right).
What’s the difference between Dana and Rubicon axles?
This Rubicon axle is referred to as a Super Dana 44. Dana 44 – For TJs, the inner and outer axle has 30 splines. JK Rubicon model front axles have 30 inner splines and 32 outer splines. The rear inner has 32. Note: Rubicon model Dana 44 axles are not the same length as each other due to the design of the electronic lockers.
How to identify the rear axle on a Jeep Grand Cherokee?
The video will show you where you need to look beneath the vehicle to find out which style of rear axle your Jeep Grand Cherokee has. You’ll be shown where to clean the dirt off of a specific area of the axle to obtain this important information.
How can I tell if my Jeep has a Dana axle?
The illustration below will help identify the Dana Axle in your Jeep. The model number and date are self explanatory. The Bill of Materials (B.O.M) number is stamped on the right or left hand tube of the driving axles and with the help of a Spicer catalog you should be able to get all the specs and part numbers for the axle.
What kind of rear axle does a jeep have?
Most Jeeps in the 90s came with three types of rear axles: Chrysler 8.25, Dana 35 or Dana 44. Some XJ Cherokees have the Dana 44, but its a pretty rare occurrence. ZJ Grand Cherokees with the V8 engine have a Dana 44 rear end, and some of the 4.0-liter ZJ with a tow package do too.
What’s the axle ratio on a jeep Dana 44?
Use of the Dana 44 in 1986 began somewhere between serial numbers ending with 049379 and 054173. The axles were flanged and 30 spline. Common ratios were 2.73 and 3.31. All CJ Dana 44s use a 5 on 5.5″ wheel bolt pattern.
This Rubicon axle is referred to as a Super Dana 44. Dana 44 – For TJs, the inner and outer axle has 30 splines. JK Rubicon model front axles have 30 inner splines and 32 outer splines. The rear inner has 32. Note: Rubicon model Dana 44 axles are not the same length as each other due to the design of the electronic lockers.