How do I remove SIM card from Jaguar?
To fit a micro SIM card, insert the card with the contacts facing up and the shortest end facing out. The card should not be protruding once correctly inserted. Once the micro SIM card is fitted, enable mobile data connectivity. To remove a SIM card, gently push in (1) and release (2).
How do you connect to WiFi on a Jaguar?
You insert a data-only SIM card into the card reader in your Jaguar and turn on Wi-Fi Hotspot via the Touchscreen. A data signal is then provided by the local 4G mobile network via a roof-mounted antenna.
Is Ubigi safe?
Like physical SIM cards, eSIM such as Ubigi eSIM provide the most secure and private ways to connect to the Internet.
How do you connect to WIFI on a Jaguar?
How to remove cylinder head on Jaguar XJ6?
John Karr wrote: I’m also removing the head myself. Egad, my kingdom for the job to ..some (hopefully) useful info about removing the cylinder head yourself. First, be sure to read the excellent online book “The Jaguar XJ6 from bumper to bumper” by Jim Isbell (another member of the list). This has a very good section on cylinder-head lifting.
Can you replace the headlining on an XJ6?
The headlining in my XJ6 is sagging, so I decoded to replace it. It’s not an uncommon issue, and you can get the material quite easily. After it arrived I started phoning round for a local interior specialist to have someone remove the old headlining, re-trim it and replace it.
How to remove timing cover on Jaguar XJ6?
Disconnect the two large diameter water hoses and remove the pump and top hose to a place of safety. The preliminaries completed, you can now start removing the timing cover which is held on by a total of 19 bolts – see drawing – note that three of these holding the water pump in place are already removed.
How to remove chain guide on Jaguar XJ6?
Remove the secondary chain tensioner held by two bolts (note wrong bolts in picture – they should be flanged head bolts M8 x 25mm – and are now!). It should have an arrow pointing upwards, and can only be removed after the camshaft position sensor has been removed – remove carefully as the piston will be expanded on the end!
John Karr wrote: I’m also removing the head myself. Egad, my kingdom for the job to ..some (hopefully) useful info about removing the cylinder head yourself. First, be sure to read the excellent online book “The Jaguar XJ6 from bumper to bumper” by Jim Isbell (another member of the list). This has a very good section on cylinder-head lifting.
The headlining in my XJ6 is sagging, so I decoded to replace it. It’s not an uncommon issue, and you can get the material quite easily. After it arrived I started phoning round for a local interior specialist to have someone remove the old headlining, re-trim it and replace it.
How to remove rear view mirror on XJ6?
Remove rear rail (same as side ones). Unscrew/remove rear view mirror and sunvisors. Remove front cant rail (not clipped on). Pull headlining material away from current board. Carefully cut around board. Try to not scratch the inside of the roof, and pull the old board out of the roof rails. Remove windscreen.
Can a JAG 6 cyl head come off easily?
So unlike many engines where the head comes off easily once you’ve managed to get the head/block face split, the jag 6-cyl head has to be fought all the way!