What should I do if my Jaguar is disabled?
Start the engine of the disabled vehicle. If repeated attempts to start the disabled vehicle are needed, allow the donor vehicle to idle for a few minutes between attempts. Do not switch on any electrical circuits on the previously disabled vehicle, until after the jump leads have been removed.
What to do with chain guides on Jaguar XJ6?
Put rag in hole to avoid any possibility of anything dropping into the housing which would seriously upset your day. Remove the secondary chain tensioner held by two bolts (note wrong bolts in picture – they should be flanged head bolts M8 x 25mm – and are now!).
What do you need to overhaul a Jaguar XJ6?
The work area must be cleared of the undertray, belts, alternator (pivot out of the way), compressor (move out of the way), compressor support bracket, water pump, crankshaft position sensor and radiator fans. There is no need to remove the radiator, drain the sump or disconnect the air conditioning.
Where is the spacer on a Jaguar XJ6?
This will lead to gnashing of teeth and the need to take the timing cover off again. Push the spacer back onto the crankshaft and locate the woodruffe key in its slot.
Can a small chip be repaired on a Jaguar?
At Jaguar, we know how frustrating a scratch on your bonnet, or a chip in the windscreen can be. With SMART Repair, a small scratch or chip doesn’t have to be so annoying.
Is it worth it to repair a small mark on a Jaguar?
And since there is no need to raise an insurance claim, you’ll keep your no claims discount protected and reduce the chance of your insurance premium going up. So the next time you need a minor repair, avoid all that frustration and choose a SMART solution.
What does smart repair on a Jaguar mean?
At Jaguar, we know how frustrating a scratch on your bonnet, or a chip in the windscreen can be. With SMART Repair, a small scratch or chip doesn’t have to be so annoying. SMART stands for Small and Medium Area Repair Technique, It means we can repair anything from a scratch or bumper scuff to a dented wing.
How to rebuild the rear end of a Jaguar?
Inner stub shaft of Jaguar center section all together, ready for final pulldown with the huge nut on the shaft. The crush spacer must be started with the press, then finished off with the big nut for accurate preload. Ready to start pressing. Note the green grease, a synthetic bearing grease, said to be about as good as it gets.