How to clear DTC p1582 on a Jaguar?
Action: To clear DTC P1582 follow the workshop procedure outlined below: PROCEDURE FOR CLEARING DTC P1582 1. Navigate to ‘Vehicle Configuration Main Menu’ in WDS. 2. Navigate to ‘Special Application’. 3. Navigate to ‘ECM Data Recorder’. 4. Follow on-screen instructions. Page 2 of 2 Bulletin Number XT303-01 Date of issue 04/02 5.
How do you reset the ECU on a Jaguar?
You have to reset the global closing too. Drop each window to bottom, hold “down” button down for 5 seconds then lift the window. Has to be done one by one. • The trip computer will lose all recorded trip data and all trip functions will be reset to zero. The vehicle total odometer reading is retained.
How to calibrate the parking brake on a Jaguar?
4 Confirm that the message “NOT CALIBRATED” or “APPLY FOOT AND PARK BRAKE” is displayed on the instrument cluster message centre. This indicates the the parking brake is in calibration mode. 5 Lightly press the foot brake. 6 Apply the parking brake by using the EPB switch. 7 Release the parking brake.
How do you reset the trip computer on a Jaguar?
Drop each window to bottom, hold “down” button down for 5 seconds then lift the window. Has to be done one by one. • The trip computer will lose all recorded trip data and all trip functions will be reset to zero.
What are the drive cycle procedures for a Jaguar?
Using WDS, check for and clear flagged DTCs. Start engine and bring to normal operating temperature > 82 °C (180 °F). Drive the vehicle in 3rd gear at 2500 rpm. Maintain a steady speed for 1 minute, then lift foot completely off accelerator and coast for a minimum of 10 seconds. We do not have the procedures at this time.
What should the engine temperature be in a Jaguar OBD-2?
Oxygen sensor heaters: Start engine and bring to normal operating temperature > 82 °C (180 °F). Idle engine for 3 minutes. Start engine and bring to normal operating temperature > 82 °C (180 °F). Idle for a minimum of 10 minutes.
What are the OBD procedures for a Jaguar?
Welcome to the Jaguar onboard diagnostics OBD-II drive cycle information page. The procedures detailed below apply to many but not all 1996-newer Jaguar models. The steps should generally be the same but refer to an authorized Jaguar repair/service guide or possibly owners manual to confirm steps for your Jag.
How to reset the ecu-1 Jaguar car forum?
Restart the clock (where fitted) and set it to the correct time. Simultaneously press “>>” “PTY” “A.MEM” should only take 2 or 3 seconds and the radio turns on. 1. NOTE: After the battery has been disconnected it is necessary to