When did the windshield wiper quit working on my Hyundai Santa Fe?
The contact owns a 2004 Hyundai Santa Fe. While driving 20 mph in the rain, the passenger side windshield wiper shut off. The dealer has not inspected the vehicle. The current and failure mileages were 39,995. Windshield wipers bolts have loosened 5 times since 2003. The latest was on 4/12/07. The time before was 0 on 1…
What happens when a windshield wiper relay goes bad?
When the relay is faulty, the windshield wipers will only work at the same speed that the last relay signal was sent. In layman’s terms, if you had your windshield wipers on the slow speed the last time they were active, and you turn them on again under a different setting, the relay switch should send that updated information to the module.
How do you fix intermittent windscreen wiper fault?
Fit the new motor in place and refit all components but not the wiper arms switch the ignition on and push the wiper leaver up to max speed then down to stop, turn the ignition off and fit the wiper arms just above the black part of the windscreen so that the wipers do not hit the body or the plastic in operation.
Is the windshield wiper on my Hyundai Sonata not working?
2013 Hyundai Sonata Intermittent wipers not working. Justanswer mechanic instructed me to install new wiper motor but that did not solve the … read more Subaru and Nissan factory t…
Are there any problems with the Hyundai Santa Fe wiper?
In addition when the low beams are in use, the myvision on both sides of the car is blocked out. This seems to be a common complaint which Hyundai will not address claming there is no fix since the lights are performing as designed.
Where is the intermittent wiper switch on a Hyundai?
o In areas where water freezes in winter, use windshield washer antifreeze. If a single wipe is desired in mist, push the windshield wiper and washer control lever upwards. To use the intermittent wiper feature, place the wiper switch in the “INT” position.
How to use the windshield wiper / washer switch?
Windshield wiper/washer switch 1 OFF – Off. 2 INT – Intermittent wipe. 3 LO – Low wiper speed. 4 HI – High wiper speed. B : Intermittent wipe time adjustment. C : Wash with brief wipes. D : Rear wiper/washer control: · – Spraying washer fluid. 5 OFF – Off. 6 INT – Intermittent wipe (If installed). 7 ON – Continuous wipe.
Why are the wipers on my car not working?
My husband put them in an upward position off the windshield because we were expecting a snowstorm. I put them down to go to the store and they were working but when I came out and put them on nothing happened, they would not move. The motor is still working, I hear it but the wipers won’t move.