Where do I Send my airbag control module?
This is why we always recommend that you send in your original airbag control module from your vehicle. Each module is coded for the VIN of the vehicle it is in. Send the airbag control module for reset or buy used?
When do airbags need to be reprogrammed?
If the airbags did deploy, you will need to get brand new airbags, and the SRS airbag control module will need to be reprogrammed to remove all the crash data and hard codes from the accident. The impact sensors and clock spring may also need to be replaced if they suffered any damage or were melted during the accident.
Why do I need to reset my Honda airbag module?
Even after a minor accident the airbag may not deploy but the seat belts will lock and airbag module will need to be reset because of crash data and crash codes that are stored in the airbag module. MyAirbags will reset your airbag control module back to its original manufacturer state clear of all codes, both soft and hard codes.
Is the airbag light still on after replacing the module?
Once the replacement airbag module has been correctly installed in the vehicle the airbag light may still turn on. Again, for the reasons detailed above, you need to verify that you have followed the correct steps and that other parts were not from a flood damaged vehicle.
This is why we always recommend that you send in your original airbag control module from your vehicle. Each module is coded for the VIN of the vehicle it is in. Send the airbag control module for reset or buy used?
Where are airbag codes stored on a ram?
Below you will find common airbag codes that can be stored in your airbag control module after your vehicle was in an accident. The best part of having your RAM’s original airbag module reset by MyAirbags is that when you get your airbag control module back and it goes back into the same vehicle that it came out of then it will be plug-n-play.
What happens when airbag module is unmatched?
The repaired module MUST GO BACK INTO THE SAME VEHICLE FROM WHICH IT WAS TAKEN. Airbag modules are matched to a specific car, like an address. Each airbag module is matched with all or part of the vehicle’s VIN. Unmatched modules will usually cause the airbag light to illuminate. Complete all other repairs first.
How does my airbag module reset and return work?
MyAirbags is committed to helping you reset your airbag module and seat belts. We provide a reset and return service to reset airbag control modules. This service requires you to remove and send your module to us for reset. When we receive your airbag module, we reset ALL fault codes.