What to do if your front wheel bearing is loose?
Make sure you torque the axle nut and peen it into the notch in the axle, the axle nut holds the wheel bearing together, if it becomes loose, you could damage the wheel bearing. Remove the axle nut and axle from the knuckle assembly. Remove the hub from the center of the bearing.
Is there a problem with my Honda wheel bearing?
(Playback ID: D5qIO0s57W6lIaoO) An error occurred while retrieving sharing information. Please try again later.
How to replace wheel bearings on your ATV?
If playback doesn’t begin shortly, try restarting your device. An error occurred. Please try again later. (Playback ID: 9zAPj3jveqq8y5W5)
How do you change a front wheel axle?
Remove the knuckle assembly from the car and prepare it for the press. Step 6. Set the knuckle assemble on the press and suspend it safely, remove the center hub, starting from the back of the bearing, and only press out the center of the bearing. Step 7. Flip it over and remove the snap ring or retaining ring from the knuckle assembly.
How much does it cost to replace wheel bearing?
This is a 2007 Mercury Mountaineer, Ford Explorer but the process will be very similar for replacing any wheel bearing hub assembly with an axle running through it. I was quoted over $650 at the stealership to do the job again so save a ton of money and do it yourself and do it properly so it won’t fail again.
Where are wheel bearings located on a truck?
If the wheel bearings are housed inside your disc brake rotor, as often seen in trucks, you will need to pry off the central dust cap to expose the cotter pin and retaining nut. To do this, use your pliers to remove the cotter pin and retaining nut and then slide the rotor forward to release the outer wheel bearing (smaller wheel bearing).
What causes a wheel bearing to be destroyed?
Heat caused by lack of lubrication can destroy a wheel bearing. Water that penetrates a sealed bearing will also destroy it. Most wheel bearings manufactured today are sealed. They come from the factory pressed together as an assembly: front race, bearing set, center race, bearing set, and outer race, with seals on both the front and rear.
Make sure you torque the axle nut and peen it into the notch in the axle, the axle nut holds the wheel bearing together, if it becomes loose, you could damage the wheel bearing. Remove the axle nut and axle from the knuckle assembly. Remove the hub from the center of the bearing.
If the wheel bearings are housed inside your disc brake rotor, as often seen in trucks, you will need to pry off the central dust cap to expose the cotter pin and retaining nut. To do this, use your pliers to remove the cotter pin and retaining nut and then slide the rotor forward to release the outer wheel bearing (smaller wheel bearing).
How long does it take to change a front wheel bearing?
Question: How long does it take to change a front wheel bearing? Answer: With all the special tools needed to do the job, it should take around one to two hours, depending on how mechanically inclined you are. © 2011 Eddie Carrara
How does a wheel bearing support the center race?
Support the center race of the wheel bearing from underneath so that when you are pressing the hub into the center race, it will not push out the rear center race through the back side of the knuckle assembly.