What does Koeo fail mean?
If a vehicle fails the initial emissions test for MIL bulb check KOER, at retest, the inspector will be prompted to check the MIL operation when the key is in the on position and the engine is off (KOEO). If the vehicle’s DTC has been repaired, the MIL will be off when the engine is running.
How to test Honda Accord for emissions problems?
Vehicle speed sensor (VSS) reads more than 3 mph (5 km/h). Connect the HDS to the vehicle’s data link connector (DLC), and bring up the READINESS CODEs screen for Catalyst in the DTCs MENU. Start the engine. Test-drive the vehicle under stop-and-go conditions with short periods of steady cruise.
Are there any problems with the Honda Accord?
No check engine lights or other dashboard indicators of problems. He also says that putting the car through a drive cycle should help to set the indicators to “ready”. 2 different Honda Service Department people say that there isn’t any specific drive cycle for these vehicles and haven’t been much help. Any ideas?
What to do if your Honda Accord engine is not ready?
If your vehicle battery has been disconnected or gone dead, these codes are erased. It takes at least three days of driving under various conditions to set the codes again. To check if they are set, turn the ignition switch to ON (II), without starting the engine.
What happens if your car fails the emissions test?
In some states, part of the emissions testing is to make sure these codes are set to complete. If all of them are not set to complete, the vehicle may fail the emission test, or the test cannot be finished. To check if the readiness codes are set to complete, turn the ignition switch ON (II), but do not start the engine.
Vehicle speed sensor (VSS) reads more than 3 mph (5 km/h). Connect the HDS to the vehicle’s data link connector (DLC), and bring up the READINESS CODEs screen for Catalyst in the DTCs MENU. Start the engine. Test-drive the vehicle under stop-and-go conditions with short periods of steady cruise.
No check engine lights or other dashboard indicators of problems. He also says that putting the car through a drive cycle should help to set the indicators to “ready”. 2 different Honda Service Department people say that there isn’t any specific drive cycle for these vehicles and haven’t been much help. Any ideas?
If your vehicle battery has been disconnected or gone dead, these codes are erased. It takes at least three days of driving under various conditions to set the codes again. To check if they are set, turn the ignition switch to ON (II), without starting the engine.
What kind of mileage does a 2000 Honda Accord get?
Reviewers especially like the 2000 Accord for its cost and performance. What is the MPG of the 2000 Honda Accord? The EPA-estimated gas mileage for the 2000 Honda Accord is 21 mpg for city travel and 27 mpg on the highway. How much is a 2000 Honda Accord worth?