How do I make a master slave drive with a jumper?
Answer: You simply set the jumper to Cable Select on both drives and depending on where you connected them to the cable the computer would know which is Master and which is Slave. If you are going to use Cable Select you need a special 40 conductor IDE cable that would determine master and slave connections.
What is a master slave jumper?
If a jumper connects pins five and six, which are the center pins on each row, it is a master. If the jumper connects pins three and four, which are the pins second to the right, it is a slave.
What is CS enabled on a hard drive?
Cable select, also referred to by the acronym CS, is a disk drive jumper setting which automatically sets the priority of a disk drive by its position on its data cable. When cable select is enabled, the drive configures itself as a primary or secondary depending on its position in the drive chain.
What type of drive uses master and slave connections?
Integrated Drive Electronic hard drives use master and slave settings to help the computer tell the two devices apart when connected to the same cable.
How do I configure a master and slave hard drive?
Steps
- Restart your computer.
- If prompted for a password, enter it and press the “Enter” key.
- Navigate to the “CMOS Setup” and press “Enter”.
- In the CMOS menu, find “Hard Disk” and then the “Primary Master” selection.
- Move the cursor to the “Primary Slave” selection and press “Enter” again.
- Edit step.
What is the jumper setting on hard drive?
You may have pins on the back of your hard drive that nothing is connected to. These pins are called jumpers, and are used to enable specific types of settings. You enable particular settings by placing a jumper shunt onto specific pins—creating an electrical circuit between them.
What is master slave configuration?
Nearly all current surgical robotic systems employ a master–slave configuration, where the surgeon uses joystick-like controls at the master console to direct the movements of the robotic instruments (slave).
How do I unlock the power plan on Surface devices?
How to unlock Power Plans on Microsoft Surface Devices
- Type regedit to open Registry Editor.
- Go to “HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Control\Power“
- Double click on “CsEnabled”
- Change Value data from “1″ to “0″
- Click OK.
- Restart your computer to apply these changes to your system.
What is the jumper setting of the hard drive?
Do SATA HDD need jumpers?
You don’t need a jumper pin on your SATA drive for desktops or servers manufactured after 2002. For older equipment, you can use a jumper on the pins to limit its data transfer rate so it can work smoothly with older, slower drives. A jumper pin is a rectangular connector that creates a circuit between two pins.
What’s the jumper setting on a Maxtor drive?
Maxtor (and Quantum) drives follow the jumper configuration noted below: The drive is configured at the factory for a cable select setting. This allows the drive to assume the proper role of master or slave based on the connector used on the cable (see the UltraATA cable figure above ).
What should the jumper settings be for Seagate?
Master or single drive. If you are installing your Seagate hard drive as the only drive in the system or if it will be the primary boot drive for the system, the jumper should be set as Cable Select.
How do I jumper a Seagate Maxtor ATA drive?
If you are connecting the drive to an older system that has a pre-UDMA Mode 3 ATA controller, or you are connecting this to a cable with a slave device that doesn’t have a cable select jumper setting, jumper the drive as Master instead by putting a jumper on the first vertical set of pins closest to the data cable.
What to do with jumper pins on Maxtor fireball?
Using the jumper pins you can establish the drive Master/Slave configuration. The Maxtor Fireball Plu KX was developed by Quantum Corporation prior to its merger with Maxtor. The following BIOS parameters are provided for customers needing to manually configure the Fireball Plus KX disk drive.