Why is iAquaLink not connecting?
If the process fails, the iAquaLink device will need to have its memory cleared by physically toggling the WiFi-Wired switch to Wired then back to WiFi. This will restart setup mode so you may attempt to connect it to your eero network again.
How do I calibrate my iAquaLink?
I think you have a calibrate function on the iAquaLink. Go to MENU>SYSTEM SETUP>TEMP CALIBRATE. This should allow you to calibrate +/- 4 degrees.
How do I reset my PDA Aqualink?
Turn “LEARN” to the off position, and hit the reset button inside the jbox. This will reset the connection. If this does not work for you, turn the power off completely to your power center at the breakers.
How do I reset my iAquaLink 2.0 WiFi?
Inside the iAquaLink 2.0, toggle the WiFi – Wired switch to clear the Wi-Fi settings and put the iAquaLink in desired setup mode. 3. After clearing the WiFi settings and with the Wired/ WiFi switch set to WiFi, use a smartphone or WiFi enabled device and go to WiFi settings.
How do you calibrate a pool thermometer?
- HOW TO CALIBRATE. A THERMOMETER.
- Fill a large container with crushed ice. Add clean tap water until the container is full. Stir the mixture well.
- Thermometers should be calibrated regularly to make sure the readings are correct. The ice-point method is the most widely used method to calibrate a thermometer.
How do you calibrate a pool heater thermostat?
Using the Allen wrench or flat screwdriver, turn the screw on the back of the thermostat one-quarter turn clockwise. This will increase the temperature calibration. Wait for the water to heat up. Now use the thermometer to recheck the temperature.
How do I reset my Jandy pool lights?
To synchronize multiple lights to the same color mode, you will need to reset to the beginning of the color mode sequence. With the lights ON, turn them OFF for five (5) seconds, then turn ON again. All of the lights will reset to the Alpine White color mode.
How do you fix Jandy PDA?
Power up the PDA and do a function check….Active member
- Open the PDA.
- Remove the membrane.
- Repair the buttons.
- Restore the contacts.
- Reassemble and test.
How do I update iAquaLink firmware?
If your phone is set to allow updates to be automatically installed, the iAquaLink app will update to the new version automatically. If your phone is set to allow manual updates only, you can download the iAquaLink app at the iOS App or Google Play App stores.
How do I find my AquaLink device number?
Enter the iAquaLink device number found on the door hanger or the device itself. To add the iAquaLink device to an account, you must be connected to the web through the same router the iAquaLink device is connected to.
Does iAquaLink work with Alexa?
Setup is Simple Log in with your iAquaLink app credentials. Once iAquaLink and Alexa are successfully connected, tap DISCOVER DEVICES.